View Single Post
Old 01-27-2018, 07:59 AM   #8
ProjectClubCar
Gone Broke
 
ProjectClubCar's Avatar
Club Car
 
Join Date: Oct 2011
Location: Galveston, Texas
Posts: 1,592
Default Re: Belts, Clutch Machining, and Springs... Oh my !!

Bear,
My little DS 290 used to go 28 miles an hour at 4000 RPMs with 12:1 years,

But that was with the rev limiter and snap tie trick





Just in case you're interested with her located, rev limiters to the left side of the oil filter, and the strap tie goes back to the back where your transaxle is......

Bear do all of those things and if you're not happy then have your clutch machined......
ProjectClubCar is offline   Reply With Quote