[ccpro]

"Take a look at your steering rack. Look at the threads on each side where the ball joint threads on to the rack. You should have equal amount of threads on each side. If you don't. Make them equal. Either run one out, or run one in. Doesn't matter at this point. You can either count the threads, or measure with a tape measure. Just back off of the jam-nut and twist the shaft either into, or out of the ball joints. Don't worry about front end alignment at this point. Just get your threads equal."


You lost me here? I'm having a the same problem. I replaced the lower steering linkage and adjusted my steering wheel. Steering is tight just never centered?