Quote:
Originally Posted by daddyscooltv
Hey are you also on the Dis forum? Good luck with getting the stering wheel off I did the same that you have done so far. If you are going to replace it this is what I ended up doing. I broke the original up with a hammer to where all I had was the hub on the stering shaft, then I took a dremil with a cutoff disk and starting cutting 2 slots into the hub across from each other being very careful to not cut into the shaft finally it weakend enough for the hub to come loose. ..... .Good Luck,
Chris
|
Worked like a charm........Thanks DCTv!!!!!!!