Buggies Gone Wild Golf Cart Forum - View Single Post

sho305 · 05-23-2011, 11:02 AM

You need the puller for the clutch, its a bolt with a rod. You can make one. The cylinder and block are all one piece on these, otherwise very simple. Note the case where the balance shaft runs in it some get loose here and knock and you can't fix it, or maybe someone here found a way. Get it timed right and make sure the oil slinger is right, you should be good to go the rest is typical torque values and such. I'd also recommend you wash under the hood really well before you start.

05-23-2011, 11:02 AM	#5
sho305 Vegas modded 420 Join Date: Jun 2009 Location: West MI Posts: 15,443	Re: G9 Engine Rebuild Advice You need the puller for the clutch, its a bolt with a rod. You can make one. The cylinder and block are all one piece on these, otherwise very simple. Note the case where the balance shaft runs in it some get loose here and knock and you can't fix it, or maybe someone here found a way. Get it timed right and make sure the oil slinger is right, you should be good to go the rest is typical torque values and such. I'd also recommend you wash under the hood really well before you start.