Quote:
Originally Posted by ishootstuff
Attached is a template to program your cable. It contains the vendor and hardware ID's, USB string descriptions, and the inverted RX\TX. Just open FT_Prog and from the File menu, choose Open Template.
FYI, if the USB end of the cable hits the positive terminal of your battery, it may fry the cable and the interface to your controller. Your controller may still work, but you may get a checksum error when trying to program it. Maybe...
|
Hope ya still read this thread......
Are the drivers installed on pc when curtis software is installed? If not, where do ya get them? I don't have the directory you outlined).