[draphty]

Hello, Hoping for some help here. I picked up this cart, non running. The guy I bought it from was in the middle of the hei conversion and relocated the electrical to the rear cross bar under the seat. I been working on this thing and comparing what was done with wiring schematics. I’ve replaced the solenoid, pulsar, new battery and using an msd dual coil pack that came with it. For the life of me, I can’t get any spark. It turns over now but that’s all. I’ve identified two wires that are disconnected over near where the electrics where located, but can’t find or figure where or if they should be hooked up. They show no voltage or ground. The wires are a red one and a black one with ring terminals. I’ve checked both switches and they both check good, but no spark. Any help would be appreciated...thanks in advance!