Buggies Gone Wild Golf Cart Forum - View Single Post

Fairtax4me · 09-17-2021, 08:16 AM

Where did you buy the pedal assembly? The switches used by the aftermarket manufacturers are usually chinese junk and wouldn't surprise me if one of those only lasted 3 days.

Orange wire going into the GCOR switch is negative for the solenoid, this should show battery voltage with the pedal UP.
Put your FNR lever in N, press the Go pedal and check voltage on the Green wire coming out of the GCOR this should be the same 12v. Move the FNR to F, and press pedal again, now the green wire should show 0v. And the solenoid should click and engage. If it does not, make sure the solenoid operates by jumping the Orange wire small terminal to ground.

You can also unplug the connector from the GCOR and check continuity on the pins for the green and orange wires on the GCOR, with pedal up should have No continuity, and with pedal pressed down there should be continuity. Checking resistance may be a better test, since some meters will show continuity even if the resistance is high.

09-17-2021, 08:16 AM	#2
Fairtax4me Bonafide Nincompoop Join Date: Dec 2015 Location: Charlottesburg Va Posts: 8,987	Re: no response from gas pedal Where did you buy the pedal assembly? The switches used by the aftermarket manufacturers are usually chinese junk and wouldn't surprise me if one of those only lasted 3 days. Orange wire going into the GCOR switch is negative for the solenoid, this should show battery voltage with the pedal UP. Put your FNR lever in N, press the Go pedal and check voltage on the Green wire coming out of the GCOR this should be the same 12v. Move the FNR to F, and press pedal again, now the green wire should show 0v. And the solenoid should click and engage. If it does not, make sure the solenoid operates by jumping the Orange wire small terminal to ground. You can also unplug the connector from the GCOR and check continuity on the pins for the green and orange wires on the GCOR, with pedal up should have No continuity, and with pedal pressed down there should be continuity. Checking resistance may be a better test, since some meters will show continuity even if the resistance is high.