1994 club car ds not running

[Budule]

post some pics of the wiring...its easy to cross things up....

[Sergio]

Originally Posted by tcb2020

i replaced both microswitches and still have nothing no solenoid click and no movement

Keep in mind those two micro-switches are wired differently.

The micro-switch inside the VGlide uses the N.C. terminal and the FNR uses the N.O. terminal.

The Vglide micro-switch connections are the two terminals furthest apart (COM and N.C.).

[Mooncarter]

Originally Posted by Sergio

The 36v VGlide resistor model was available in 1994, but now that You mentioned, that was the odd ball year when some Club Car engineer decided to have a negative key switch using a red wire

I will edit the original post to include the colors for the early 1994 negative key switch to be safe

Yes. I think he was also the lead engineer on the design of the football bat.

[Budule]

Originally Posted by Sergio

odd ball year when some Club Car engineer decided to have a negative key switch using a red wire

I will edit the original post to include the colors for the early 1994 negative key switch to be safe

Hold on now , in that guys defense ,..................................i got nothin......

[tcb2020]

i had no voltage on the the two solenoid posts but when i went yellow wire to positive and green wire to positive i had 38 volts on both posts

[Sergio]

Originally Posted by tcb2020

i had no voltage on the the two solenoid posts but when i went yellow wire to positive and green wire to positive i had 38 volts on both posts

That was not one of the tests for the negative key switch system.

If You have no voltage between the Green and pack negative, the issue is the micro-switch inside the VGlide.

If you just replaced it, make sure you used the correct terminals on that switch: COM and NC..

Also make sure there is no diode on the solenoid small posts.

[tcb2020]

i have a positive key switch though so i ran the tests for the positive key switch

[tcb2020]

also i have it on com and nc in the correct spots

[Sergio]

If You have a "positive key switch", then your first test was the wrong one.

Yellow to pack negative should be 36v or the micro switch in the FNR is bad.

That micro-switch uses the COM and NO terminals.

You should also verify that you do have +36v on the blue wire at the FNR micro-switch or the issue is with the key switch circuit.

[tcb2020]

okay i will test that and get back to you soon