Logging on Alltrax and settings

[daprincipal]

I am trying to log so I can send it to Alltrax but can't seem to figure out where it is storing the file in the Alltrax folder.

Also I have the RPMS set at 5500 and it seems to hit its limit and jerks a little back and forth. Is this because the regen is set low? Very new to all this so do not be afraid to speak to the basics.

What do most people keep their regen settings at? Maximum RPM.

Running an Alltrax 300 with a stock motor. I do have the correct field map already uploaded from Altrax.

[scottyb]

When you ask it to log a monitor file a window pops up which allows to select anywhere in your laptop, the easiest selection is desktop, then tell it open or ok.

6000 rpms is the max for any stock motor and 99% of all aftermarket motors... some can go a few hundred rpms faster but generally 6G is a safe setting.

Reduce the regen completely and see if that fixes the bouncing at the top end.
You may also want to go into tools and hit auto re calc for the throttle to retry to map your pedal signal. IF problems persist unreasonably the MCOR may be hash. Replace it

[daprincipal]

I went into tools and did not see a recalc for the pedal. Nothing else I need to do first?

Originally Posted by daprincipal

I went into tools and did not see a recalc for the pedal. Nothing else I need to do first?

Clear Auto-Cal is not included in the Tools selection. Instead, you can find it in the Controller selection.