|
|
|||||||
| Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
04-26-2019, 01:33 PM
|
#1 |
|
Nincompoop Club Member
Join Date: Jun 2016
Location: Idaho
Posts: 1,216
|
Need advice on replacing differential seal 85 Marathon
I noticed the other day a few oil drops on the inside of the left rear wheel and on the brake drum, So it must need a new axle seal. Any advice on installing it would be appreciated, I figure on replacing the bearing too while I'm at it and can't seem to find a part number on the seal or bearing. Help and Thanks
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
04-26-2019, 01:39 PM
|
#2 |
|
Vintage tech
Join Date: Sep 2009
Location: South
Posts: 3,297
|
Re: Need advice on replacing differential seal 85 Marathon
 Which cart do you have ? Never mind I see its an 85 me slow today |
|
|
|
04-26-2019, 02:36 PM
|
#3 |
|
Nincompoop Club Member
Join Date: Jun 2016
Location: Idaho
Posts: 1,216
|
Re: Need advice on replacing differential seal 85 Marathon
Yep 85 Marathon, The one in my avatar pic. Hmmm, Maybe it's time I should post up a new close up pic. Anyway, I found the diagram in an 88 manual that doesn't show part numbers and doesn't look as simple of a job as I hoped. Not sure if it's the same for an 85??
It shows after removing brake drum and hub there's an axle bearing that I'm assuming must be a sealed greased bearing because behind it is the oil seal, IF mine's like that then the diff oil is getting past the seal and continuing on past and through the sealed greased bearing. That can't be good lol, Ughh!! |
|
|
|
|
04-26-2019, 02:44 PM
|
#4 |
|
Test before replacing
Join Date: Aug 2013
Location: Ohio side of the Pennsylvania border.
Posts: 3,572
|
Re: Need advice on replacing differential seal 85 Marathon
This might be it. https://www.golfcartking.com/ezgo-rear-axle-seal/
|
|
|
|
|
04-26-2019, 02:56 PM
|
#5 |
|
Vintage tech
Join Date: Sep 2009
Location: South
Posts: 3,297
|
Re: Need advice on replacing differential seal 85 Marathon
Here ya go. Hope it
 helps |
|
|
|
|
04-26-2019, 03:08 PM
|
#6 |
|
Nincompoop Club Member
Join Date: Jun 2016
Location: Idaho
Posts: 1,216
|
Re: Need advice on replacing differential seal 85 Marathon
Thanks y'all, And Yes Yes it's confirmed. Sadly for me that's the same diagram I found for the 88's
|
|
|
|
|
04-27-2019, 04:42 PM
|
#7 |
|
Nincompoop Club Member
Join Date: Jun 2016
Location: Idaho
Posts: 1,216
|
Re: Need advice on replacing differential seal 85 Marathon
Ok now I'm answering my own posts LOL
 But just in case anyone else needs to know, I believe (from searching) this is the correct bearing and seal. Of course I won't know 100% for sure till I remove the old ones Axle Bearing-600411 Axle Seal-AC12329 |
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| replacing G16 bearings. rubber seal ?? | Gas Yamaha | |||
| Need part# for differential input shaft seal 85 Marathon | Gas EZGO | |||
| 93 marathon driven clutch seal | Gas EZGO | |||
| Looking for advice replacing a TXT with a Precedent | Electric Club Car | |||
| Marathon crank seal | Gas EZGO | |||
Linear Mode
