Need info on Logisystems board resistor size PLEASE

[jonequest]

I have a non working Logisytems controller that I opened up and found the bad parts, two little resistors. What I need help with is I don't know what size the resistors are. If ayone has one of these laying around I could really use the info if you can peek at the little controller board for me. This is howe I got apart in less than ten minutes.

I got tired of sitting on my hands so I used a heat gun to soften the epoxy and ran a razor around the edges to seperate the epoxy from the leads. Then I popped out the foam epoxy cover as one piece and removed it. The next step was removing the silicone sealant covering the screw heads and removed the screws. After that the who slides right out. I instantly seen the problem. There are two little resistors burnt on the control board of the low amperage circuit. The mosfets looked OK but who knows for sure. My biggest problem now is figured out what impedance those $.03 resistors are so I can replace them. I can see half the bands on one and none on the other so I am kind of stuck at the moment. I could make a educated guess but if Logisystems would answer the phone they could tell me pretty easily. At least I have some answers now.

Does anyone wanna open one of these baby's up and take a look for me??

John