|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
08-26-2021, 09:09 AM | #1 |
Not Yet Wild
Join Date: Aug 2021
Posts: 5
|
All signs point to bad speed sensor, but....
2012 Club Car Precedent, 48v 6x8v
Our street flooded in May and used the cart to bring my neighbor home through some high water. It ran normal for a day or two after. Then it went into limp mode 8mph top speed. Ordered speed sensor and put it in, no change. Then a couple days later, it would only move 5-10 feet and die. Had to wait a minute then move 5-10 more. Pulled the motor, which was a year old DD Torque motor. Some water came out and it had a little corrosion in there. Called DD and they wanted me to ship it back to rebuild it but because of the cost to ship both ways, I decided to buy a new one. Installed new motor and no change. Still moved 5-10 feet and died. After some testing I determined the solenoid was bad. Replaced it and the cart works again! But it's back in limp mode 8mph. When I push the cart in run mode, no beeping or braking. Has to be the speed sensor, right? But the speed sensor is brand new, and I have another brand new one that I swapped out and no change. Then I have a 3rd one (the one that flooded), tried it and no change. Tried 2 different magnets too. If it's not the speed sensor, then what else could it be? Has plenty of power until it hits 8mph. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-26-2021, 09:14 AM | #2 |
Gone Wild
Join Date: Sep 2020
Location: Greater Myrtle Beach Area
Posts: 153
|
Re: All signs point to bad speed sensor, but....
If you trace the wires from the speed sensor back to the harness you may find corrosion in a connector that was submerged at some point. Happens to vehicles up here in the NY area due to long term exposure to snow and salt....
|
08-26-2021, 12:01 PM | #3 |
Not Yet Wild
Join Date: Aug 2021
Posts: 5
|
Re: All signs point to bad speed sensor, but....
I thought about that too...the wires go into a sleeve and disappear, lol. But I'm guessing they go to the controller? The controller and all wiring look fine physically from what I can see and they weren't submerged in water like the motor and speed sensor were. The MCOR was submerged too but it doesn't seem like the MCOR would cause these symptoms.
|
08-26-2021, 04:27 PM | #4 | |
Gone Wild
Join Date: Apr 2020
Location: 1000 Oaks, SOCAL
Posts: 424
|
Re: All signs point to bad speed sensor, but....
Quote:
|
|
08-26-2021, 04:59 PM | #5 |
Gone Wild
Join Date: May 2021
Posts: 289
|
Re: All signs point to bad speed sensor, but....
Have you checked your voltage? If its not the speed sensor. Could be dropping out?
|
08-27-2021, 11:05 AM | #6 | |
Not Yet Wild
Join Date: Aug 2021
Posts: 5
|
Re: All signs point to bad speed sensor, but....
Quote:
I did check voltage of the battery pack, at full charge it's 50.9V. At full throttle it goes down to 47 then settles at 48v. I'm guessing a little voltage drop is normal? |
|
08-27-2021, 01:37 PM | #7 |
Not Yet Wild
Join Date: Aug 2021
Posts: 5
|
Re: All signs point to bad speed sensor, but....
OK, I checked continuity between 2 of the 3 wires. Red and Green go to the controller, purple goes somewhere else, looks like it might go to the MCOR. Red and green both have continuity. I'm going to try and find a wiring diagram to find out where purple goes.
|
08-27-2021, 01:52 PM | #8 |
Gone Wild
Join Date: Dec 2009
Location: Aiken, SC
Posts: 13,176
|
Re: All signs point to bad speed sensor, but....
On a newer cart purple is ground
|
09-27-2021, 01:17 PM | #9 |
Not Yet Wild
Join Date: Aug 2021
Posts: 5
|
Re: All signs point to bad speed sensor, but....
OK, I'm going to bump this thread because I need to get back to trouble shooting again. Hurricane Ida came through on 8/29/21 and did a lot of damage around here but things are starting to settle and I need to get this cart running top speed again.
Yes, purple is ground, I found a wiring diagram but it doesn't show where the purple wire goes after it leaves the speed sensor. It looks like it goes to the MCOR, but I haven't dug my way in there to check. And it's just a ground. Could it be a bad controller? I hate to bring it to a local shop, but I may break down and do that if I can't figure this out. |
09-27-2021, 04:40 PM | #10 |
Gone Wild
Join Date: Sep 2016
Location: Titusville, FL...Space Coast
Posts: 591
|
Re: All signs point to bad speed sensor, but....
Another possibility is that the controller isn't releasing the solenoid causing a main driver on fault which will put the cart in limp mode...Next time it is in limp mode turn the key off and listen closely to the solenoid to see if you can hear it disengage...
|
|
|
Similar Threads | ||||
Thread | Forum | |||
2013 EZGO TXT 48V Speed Up starting point | Electric EZGO | |||
MCOR? Speed Sensor? Controller? Cart Runs at half speed. Advice, please. | Electric Club Car | |||
WTB Ezgo Speed Sensor Cable (Without Sensor) | Golf Carts and Parts | |||
Is this signs of a bad speed sensor? | Electric Club Car | |||
08 precedent electric speed sensor problem. Cart starts at proper speed then slows . | Electric Club Car |