|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
06-29-2016, 10:05 AM | #1 |
Not Yet Wild
Join Date: Jun 2016
Location: Prescott, WI
Posts: 16
|
Oil light on - Need Part Number
My oil light came on last night. The oil level is good! I have done the research and understand I may have a bad oil sensor. I don't have a part list or diagram and am hoping someone can help me with the part number(s). Could the reason the lite is on be anything else?
Its for a gas 2008 Yamaha - YDRA. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-29-2016, 10:47 AM | #2 |
Gone Wild
Join Date: Mar 2013
Location: DORR MI
Posts: 230
|
Re: Oil light on - Need Part Number
assuming an engine serial# would help? or they might be pretty general
|
06-29-2016, 12:02 PM | #3 |
Not Yet Wild
Join Date: Jun 2016
Location: Prescott, WI
Posts: 16
|
Re: Oil light on - Need Part Number
I will have to check the engine for the serial number. I know its a G29.
|
06-29-2016, 12:33 PM | #4 |
It's Beer Time!
Join Date: Sep 2010
Location: Vineland, NJ
Posts: 1,462
|
Re: Oil light on - Need Part Number
When's the last time you changed the oil? It may just have some junk in there laying on the sensor or there may be something up with the wiring from the sensor to the light.
I'm not completely sure about your model but for my G8 & G16 the engine has to come out and the side case has to come off to get to the sensor. The sensor is attached to the case cover. It's not hard to pull the motor but I'm not sure I'd wanna do it for the oil light sensor. |
06-29-2016, 01:21 PM | #5 |
VC 460 CLONE GONE WILD
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,644
|
Re: Oil light on - Need Part Number
On my G14 it was mounted on the bottom of the oil sump.Easy to change from the underside of the cart.
|
06-29-2016, 01:47 PM | #6 |
Not Yet Wild
Join Date: Jun 2016
Location: Prescott, WI
Posts: 16
|
Re: Oil light on - Need Part Number
I just changed the oil on Saturday....I wish I could post a link or picture to the part I think I need!
Last edited by jimhoepfl; 06-29-2016 at 01:48 PM.. Reason: add |
06-29-2016, 10:19 PM | #7 |
Not Yet Wild
Join Date: Jun 2016
Location: Prescott, WI
Posts: 16
|
Re: Oil light on - Need Part Number
Can anyone help me with where the oil sensor is located on the G29?
|
06-30-2016, 02:37 AM | #8 |
Crazy Ole Man
Join Date: Jan 2016
Location: Owego NY
Posts: 2,758
|
Re: Oil light on - Need Part Number
Just curious -- is it causing it to run funny or not at all? On the G2 the oil light is operated through the ignition module and it caused mine to run erratic then not at all. Checked my oil -- all was fine. Disconnected the sensor lead from the engine -- started and all is well. Long story but it may not be the sensor -- it may be a short.
|
06-30-2016, 05:55 AM | #9 | |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,316
|
Re: Oil light on - Need Part Number
Quote:
If you keep an eye on the oil level, the sensor/light isn't really necessary. Duct tape... |
|
06-30-2016, 08:50 AM | #10 |
Not Yet Wild
Join Date: Jun 2016
Location: Prescott, WI
Posts: 16
|
Re: Oil light on - Need Part Number
The cart runs fine with the light on. The light will not turn off without disconnecting the sensor. I don't want to just put tape over it because it will still drain my battery when on. I have a wife and kids who "forget" therefor I am looking to make the repair.
|
Tags |
gas yamaha, oil sensor, part number |
|
|
Similar Threads | ||||
Thread | Forum | |||
Need a part number? | Electric Club Car | |||
I need a part number..... | Electric EZGO | |||
need a part number | Gas EZGO | |||
anybody know the part number or name of these? | Electric EZGO | |||
part number | Gas Yamaha |