2009 RXV (electric) problem

[cgtech]

Originally Posted by lambert65

I have a 2010 RXV with nearly the exact same problem. Replaced solenoid. Meter still reads "E" as if total power loss. Can disconnect plugs to release brake. Checked voltage at terminals on solenoid and seems fine with key on. Checked wiring at pedals and cup holder jumper plug. Checked all fuses. Reverse horn very audible. However, cart doesn't move. Hate to spend money on controller because based on above post that didn't solve problem.

Search for resistor control module for your specific problem.

[Sclanton043]

Waiting for parts....I ordered the relay and also an aftermarket
motor brake.

[Sclanton043]

I installed a new brake, and that didn't fix it either. I have a new
controller, new brake, and new solenoid on the cart now.
All the fuses are good.

I have power at the state of charge meter when the key is on,
but no solenoid click, and no reverse buzzer. Cart won't move.

Not sure what to do now.

[usgicollector]

Originally Posted by cgtech

Search for resistor control module for your specific problem.

Did you read cgtech comment?

[seanb97072]

I have same problem

[Sclanton043]

Hi USGICollector,

I think CGTECH was advising Lambert65 with that comment,
who has a different problem than mine.

Either way, the resistor control module was replaced as part
of the new (remanufactured) controller I put on.... so it did get replaced.

A mechanic came over today with the Dahaher handheld diagnostic
device, but couldn't get any error codes... he assumes that because
I have already replaced the original controller, the diagnostic information is
on the original controller, and this new controller is "blank" and has
nothing to report because it has not gone through the initial power-on
sequence yet.

[Sclanton043]

Originally Posted by lambert65

I have a 2010 RXV with nearly the exact same problem. Replaced solenoid. Meter still reads "E" as if total power loss. Can disconnect plugs to release brake. Checked voltage at terminals on solenoid and seems fine with key on. Checked wiring at pedals and cup holder jumper plug. Checked all fuses. Reverse horn very audible. However, cart doesn't move. Hate to spend money on controller because based on above post that didn't solve problem.

Lambert65 your symptoms are different than mine in two ways.

I DO have power at the state of charge meter, but I do NOT have
a backup buzzer.

[Sclanton043]

I put the old controller back in to see the diagnostic report.


Error Log
code ltime
12576 1090.5
9024 1088.4
25107 1079.1
12833 775.1