Kill switch

[diesel97]

I want to put a hidden kill switch on my ezgo electric cart and was thinking of tying it inline with one of the 2 wires on the ignition switch...would this work well?does it matter on which wire i tie into?And would any type of simple toggle switch be sufficient for this?Thank you

yes ether wire
yes a good toggle switch will work



http://www.buggiesgonewild.com/elect...-switches.html

http://www.buggiesgonewild.com/colum...ft-device.html

http://www.buggiesgonewild.com/elect...ey-switch.html

http://www.buggiesgonewild.com/road-...t-parking.html

http://www.buggiesgonewild.com/elect...ons-where.html

[diesel97]

Thank you...thank you

[scottyb]

Use a 20a automotive toggle switch in any number of locations. What cart and drive system are you asking about? It may be easier to access wiring under the seat.

[diesel97]

02 ezgo pds...i got it all taken apart and easy access to the ignition wires so figured that would be the place to tie into no?

[scottyb]

An interruption (switch) of any of the red lines shown in this diagram will disable the cart.

The best place might be to switch the red/wht wire from the charge receptacle.

[agpfl]

I used a magnetic window/door contact left over from my home alarm system inline on the red/white wire that runs to the reed switch which ScottyB mentioned. Secured the wired piece under a body panel and the other half outside the panel with a piece of velcro.

[jalipit]

I just installed a battery disconnect switch from Advance Auto in the back of one of my locking dash compartments.