Does the Admiral B2 motor have a 4 or 8 pole speed sensor?

bubba4dad · 07-26-2018, 05:24 PM

Im srtuggling... Need help

scottyb · 07-26-2018, 06:54 PM

4 pole
All Admiral motors are 4 pole.
Most all OEM motors are 8 pole
I hope this helps

bubba4dad · 07-26-2018, 07:17 PM

Ok, the controller I got from you is programmed for three different modes. 3000 rpm, 4000 rpm, and 5995 rpm. But it’s set to 8 pole.

PuttPutt · 07-26-2018, 11:02 PM

Quote:

Originally Posted by bubba4dad

Ok, the controller I got from you is programmed for three different modes. 3000 rpm, 4000 rpm, and 5995 rpm. But it’s set to 8 pole.

???? so is mine

xct 48500 with admiral b2

scottyb · 07-27-2018, 09:08 AM

The Admiral Field map is SUPPOSED to automatically set the 4 pole selection. It has in the past.
If it is not doing so now it must be an oversight with the latest revision. I will check this out today. Thank you

Select 4 pole for all Admiral motors.

scottyb · 07-27-2018, 12:25 PM

I just checked as A4 and B2 and those maps set the 4 pole selection automatically as they always have. I'm wondering if you guys are updating your controllers and resetting defaults when prompted. Default would be 8 pole.

What maps specifically are you running ?

bubba4dad · 07-27-2018, 04:48 PM

I did not reset mine to default.
When I finished the installation I took it for its break in drives. All three ml3 switch positions resulted in the same top speed of 28.4 mph. I questioned this and figured it might be due to the 8 pole setting. I have since switched it to 4 pole and it seems to be working correct on mode 1 or “normal” as it runs right at 3000 rpm and a speed of about 15 mph. Mode 2 increases the rpm to about 3500 or approximately 19 mph. Mode 3 actually goes up to about 4000 rpm or about 24 mph and then slows down to about 3500 rpm and a speed of about 19.
The field map loaded is RHMOT-B2-V4.
So I’m back to being confused again.
Still need help!

bubba4dad · 07-27-2018, 04:49 PM

I have never been prompted to reset to defaults.

bubba4dad · 07-27-2018, 04:56 PM

I did notice when driving with the laptop connected that my throttle % peaked at 90%. Is there a calibration for that?

bubba4dad · 07-27-2018, 05:08 PM

Not sure if it helps but I took a snapshot of the controller and have atached it here.

07-26-2018, 05:24 PM	#1
bubba4dad Not Yet Wild Join Date: May 2018 Location: Alvin, Texas Posts: 59	Does the Admiral B2 motor have a 4 or 8 pole speed sensor? Im srtuggling... Need help

07-26-2018, 06:54 PM	#2
scottyb Happy Carting Join Date: Dec 2007 Location: Southern California Posts: 73,410	Re: Does the Admiral B2 motor have a 4 or 8 pole speed sensor? 4 pole All Admiral motors are 4 pole. Most all OEM motors are 8 pole I hope this helps

07-26-2018, 07:17 PM	#3
bubba4dad Not Yet Wild Join Date: May 2018 Location: Alvin, Texas Posts: 59	Re: Does the Admiral B2 motor have a 4 or 8 pole speed sensor? Ok, the controller I got from you is programmed for three different modes. 3000 rpm, 4000 rpm, and 5995 rpm. But it’s set to 8 pole.

07-27-2018, 09:08 AM	#5
scottyb Happy Carting Join Date: Dec 2007 Location: Southern California Posts: 73,410	Re: Does the Admiral B2 motor have a 4 or 8 pole speed sensor? The Admiral Field map is SUPPOSED to automatically set the 4 pole selection. It has in the past. If it is not doing so now it must be an oversight with the latest revision. I will check this out today. Thank you Select 4 pole for all Admiral motors.

07-27-2018, 12:25 PM	#6
scottyb Happy Carting Join Date: Dec 2007 Location: Southern California Posts: 73,410	Re: Does the Admiral B2 motor have a 4 or 8 pole speed sensor? I just checked as A4 and B2 and those maps set the 4 pole selection automatically as they always have. I'm wondering if you guys are updating your controllers and resetting defaults when prompted. Default would be 8 pole. What maps specifically are you running ?

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

07-27-2018, 04:48 PM	#7
bubba4dad Not Yet Wild Join Date: May 2018 Location: Alvin, Texas Posts: 59	Re: Does the Admiral B2 motor have a 4 or 8 pole speed sensor? I did not reset mine to default. When I finished the installation I took it for its break in drives. All three ml3 switch positions resulted in the same top speed of 28.4 mph. I questioned this and figured it might be due to the 8 pole setting. I have since switched it to 4 pole and it seems to be working correct on mode 1 or “normal” as it runs right at 3000 rpm and a speed of about 15 mph. Mode 2 increases the rpm to about 3500 or approximately 19 mph. Mode 3 actually goes up to about 4000 rpm or about 24 mph and then slows down to about 3500 rpm and a speed of about 19. The field map loaded is RHMOT-B2-V4. So I’m back to being confused again. Still need help!

07-27-2018, 04:49 PM	#8
bubba4dad Not Yet Wild Join Date: May 2018 Location: Alvin, Texas Posts: 59	Re: Does the Admiral B2 motor have a 4 or 8 pole speed sensor? I have never been prompted to reset to defaults.

07-27-2018, 04:56 PM	#9
bubba4dad Not Yet Wild Join Date: May 2018 Location: Alvin, Texas Posts: 59	Re: Does the Admiral B2 motor have a 4 or 8 pole speed sensor? I did notice when driving with the laptop connected that my throttle % peaked at 90%. Is there a calibration for that?

Similar Threads
Thread	Forum
Admiral B2 speed sensor wire splicing	Electric EZGO
Admiral B2 speed sensor wiring	Electric Club Car
Admiral B2 speed sensor	Electric EZGO
High speed Admiral motor	Electric Club Car
D&D motor speed sensor.	Electric Club Car