G9 issues

bowtieracin · 06-06-2019, 04:22 AM

I just got this cart runs good. Until battery dies, it’s not charging. Then I find the green and red wire out of starter are unplugged, so I plug them in fire it up, still not charging. And with them plugged in cart keeps turning over after pedal is released.any ideas? Am I fighting 2 problems? I tried grounding out the green wire to Vr and still not charging. Brushes in starter look like new. I haven’t taken starter apart yet. Thanks for your help!

G1-G9 · 06-06-2019, 05:30 AM

make sure that the switch up under the throttle isn't stuck in for the rolling over problem. normally if it rolls over it will charge but there may be a problem with the regulator or it might have a broken wire in the harness because with the age of these machines they tend to have worn sections in the harness and brake.

CP241 · 06-06-2019, 06:46 AM

Agreed. Teat wire continuity between the starter/generator and voltage regulator (with all wires disconnected) to make sure the harness is in tact. And verify VR has a good ground as well. I've seen several G2/G9 with melted brown ground wires coming off the VR

06-06-2019, 04:22 AM	#1
bowtieracin Gone Wild Join Date: May 2009 Posts: 377	G9 issues I just got this cart runs good. Until battery dies, it’s not charging. Then I find the green and red wire out of starter are unplugged, so I plug them in fire it up, still not charging. And with them plugged in cart keeps turning over after pedal is released.any ideas? Am I fighting 2 problems? I tried grounding out the green wire to Vr and still not charging. Brushes in starter look like new. I haven’t taken starter apart yet. Thanks for your help!
bowtieracin Gone Wild Join Date: May 2009 Posts: 377

06-06-2019, 05:30 AM	#2
G1-G9 LIFE IS TAKING FOREVER Join Date: Apr 2010 Location: DANSVILLE NY Posts: 5,327	Re: G9 issues make sure that the switch up under the throttle isn't stuck in for the rolling over problem. normally if it rolls over it will charge but there may be a problem with the regulator or it might have a broken wire in the harness because with the age of these machines they tend to have worn sections in the harness and brake.

06-06-2019, 06:46 AM	#3
CP241 Nincompoop village idiot Join Date: Apr 2018 Location: Michigan Posts: 9,673	Re: G9 issues Agreed. Teat wire continuity between the starter/generator and voltage regulator (with all wires disconnected) to make sure the harness is in tact. And verify VR has a good ground as well. I've seen several G2/G9 with melted brown ground wires coming off the VR

Similar Threads
Thread	Forum
G1 issues yet again	Gas Yamaha
81 CC issues	Electric Club Car
Possible battery issues or charger issues	Columbia ParCar
89 gas ez go gas issues	Gas EZGO
powerdrive 2 issues and speed issues.	Electric Club Car

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum