Yamaha G2 limited slip

[webn237]

Anyone know if there is a limited slip for the Yamaha G2 rear end?

Sent from my SM-N970U using Tapatalk

[cgtech]

Sorry, none that I know of for the old (super tough) Yamaha built axles. If it were a newer Dana 12 axle, a few options would exist. Not a cheap swap tho, new motor & new axle. Not sure which newer axle would be a "bolt-in" replacement, maybe g14e or g16e? The old axle used a different spline pattern that wont allow your motor to fit on the newer axle where posi is easy.

[webn237]

Originally Posted by cgtech

Sorry, none that I know of for the old (super tough) Yamaha built axles. If it were a newer Dana 12 axle, a few options would exist. Not a cheap swap tho, new motor & new axle. Not sure which newer axle would be a "bolt-in" replacement, maybe g14e or g16e? The old axle used a different spline pattern that wont allow your motor to fit on the newer axle where posi is easy.

I forgot to mention its for a gas rear end but from what research I have been doing there is nothing either way which sucks. I can get one for my G22 but not a G2. Is there that big of a difference between the gears in the generations?

Sent from my SM-N970U using Tapatalk

[cgtech]

Huge difference, total different axle from different factory. it's not the gears that get the Posi parts, it's the ring gear carrier. Dana gas & electric axles can get it. Old Yamaha-built axles (G & E) never had any posi offered. And I did screw up about your cart being electric. Doesn't make a difference, still can't get a posi.