|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
07-18-2014, 11:11 PM | #1 |
Getting Wild
Join Date: Jun 2014
Location: Mid-Michigan
Posts: 90
|
Play in governor shaft/oil leak on G22
I picked up a 2005 G22 a few weeks ago and while having the body off for painting, I thought I'd clean up the innards. I noticed the top of the gear case near the shaft for the governor had quite a bit of buildup of crud on it that I thought was mud because there was mud almost everywhere.
When it wouldn't hose off, I found it to be a buildup of gear fluid and dirt caked on there. When I was wiping it off, I noticed the shaft of the governor to have quite a bit of play side to side. I'm sure the seal (if there is one) is shot, but for those who have taken their gear box apart, does it sound like I have a bad bushing/bearing on the top end of the governor? Any ideas? Thanks, Carl |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-19-2014, 11:27 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Play in governor shaft/oil leak on G22
Been there, done that. Not sure the bushing has an official part number.
|
07-20-2014, 06:55 AM | #3 |
Getting Wild
Join Date: Jun 2014
Location: Mid-Michigan
Posts: 90
|
Re: Play in governor shaft/oil leak on G22
Thanks for the reply. Any insight on how to replace? I attached a pic I found (not mine) that I have pointed to at the bottom where I think mine is bad.
Can't find much info at all on this. It must not be a common problem, or I'm not using the correct terms while searching. |
07-20-2014, 12:04 PM | #4 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Play in governor shaft/oil leak on G22
I think finding the repair bushing is the uncommon part. The seal is easy to find. We are talking about the same thing.
|
07-20-2014, 02:46 PM | #5 | |
Getting Wild
Join Date: Jun 2014
Location: Mid-Michigan
Posts: 90
|
Re: Play in governor shaft/oil leak on G22
Quote:
And the seal is: 93109-10820-00 SEAL, OIL And of course, with my luck, I assume these are installed from the inside of the trans case before the governor shaft is put in.......(?) |
|
07-21-2014, 01:24 AM | #6 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Play in governor shaft/oil leak on G22
Yep, goes inside the axle housing. I would remove everything to keep any crud out of your gears.
|
05-04-2019, 11:06 AM | #7 | |
Not Yet Wild
Join Date: May 2016
Location: North Canton, OH
Posts: 40
|
Re: Play in governor shaft/oil leak on G22
Quote:
|
|
05-04-2019, 01:07 PM | #8 |
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: Play in governor shaft/oil leak on G22
|
|
|
Similar Threads | ||||
Thread | Forum | |||
G29 oil leak on secondary clutch shaft | Gas Yamaha | |||
Oil leak on back shaft vent ezgo electric | Electric EZGO | |||
input shaft play? | Gas Yamaha | |||
Oil leak at input shaft seal | Electric Yamaha | |||
Kiwasaki Rear-end shaft play in 96CC | Electric Club Car |