|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
10-03-2018, 06:43 PM | #1 |
Not Yet Wild
Join Date: Oct 2018
Posts: 42
|
G2 goes from 0 to full speed, nothing in between
Hi all, just purchased a new to me, used 1987 G2-AB cart.
Looking for guidance/advice for the, i guess, drivetrain. Engine has no issue starting but I have to give it a lot of gas for the cart to get moving. Once it does, it gives a jerk and starts going but at full speed. Drive belt has been replaced with a new one. Where should I start looking? Any advice would be greatly appreciated. Thanks |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-04-2018, 04:53 PM | #2 |
Not Yet Wild
Join Date: Oct 2018
Posts: 42
|
Re: G2 goes from 0 to full speed, nothing in between
Think I found my problem.
The spring in the secondary clutch is broken. |
10-04-2018, 05:00 PM | #3 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,316
|
Re: G2 goes from 0 to full speed, nothing in between
The spring seat looks tore up, and the sheaves are probably worn. I would suggest replacing the entire clutch assy. Both sheaves, spring seat and spring. You'll never have to do it again.
There's this, which is much better than aftermarket parts from china. http://www.plowmanscarts.com/carts.c...1522181677&v=2 |
10-04-2018, 07:47 PM | #4 | |
Not Yet Wild
Join Date: Oct 2018
Posts: 42
|
Re: G2 goes from 0 to full speed, nothing in between
Quote:
I tried to undo the bolt but everything seems to turn. Not sure how to lockup the transmission or wheels to remove the clutch. Thanks |
|
10-05-2018, 05:28 AM | #5 |
LIFE IS TAKING FOREVER
Join Date: Apr 2010
Location: DANSVILLE NY
Posts: 5,327
|
Re: G2 goes from 0 to full speed, nothing in between
At the point that you are at I would use a big pipe wrench to hold the clutch to get the nut off. Then replace everything.
|
10-05-2018, 06:21 AM | #6 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,316
|
Re: G2 goes from 0 to full speed, nothing in between
I've never had a problem holding the clutch with my hand and using an impact on the nut. You may need a clutch puller to remove the sheaves.
|
10-05-2018, 07:50 AM | #7 |
Gone Wild
Join Date: Mar 2018
Location: The Desert
Posts: 248
|
Re: G2 goes from 0 to full speed, nothing in between
|
10-05-2018, 08:20 PM | #8 |
Not Yet Wild
Join Date: Oct 2018
Posts: 42
|
Re: G2 goes from 0 to full speed, nothing in between
Thanks everyone for the input.
Ordered clutch and will try to remove the old one before the new one gets in. |
10-12-2018, 02:43 PM | #9 |
Not Yet Wild
Join Date: Oct 2018
Posts: 42
|
Re: G2 goes from 0 to full speed, nothing in between
After some fighting and elbow grease, the new clutch is in.
|
10-12-2018, 04:55 PM | #10 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,316
|
Re: G2 goes from 0 to full speed, nothing in between
That belt is worn out. A new belt should ride close to the top of the sheaves.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
EZ GO TXT full speed reverse and 1/4 speed forward | Electric EZGO | |||
Loud noise and clicking at full speed on new high speed motor. | Electric EZGO | |||
Golf cart slowly losses speed and come to stop but in 5 mins back to full speed?? | Electric Club Car | |||
1204 controller, half-speed forward full speed reverse | Electric EZGO | |||
Full speed forward, full speed reverse | Electric EZGO |