|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
08-04-2016, 05:33 PM | #1 |
Not Yet Wild
Join Date: Aug 2016
Posts: 4
|
G9 shift cable adjustment
Replaced both shift cables, F&R, but have not been able to adjust cables enough to engage the transmission in both F&R. The arm that the cables are attached to on the transmission moves about 95% of the way and almost engages the transmission but not quite. I can use my hand to move it the rest of the way and there is like a click to move the last fraction of an inch to engage. The cables are tightened/shorten completely but it feels like it needs to be tightened a bit more to get the transmission to "click" into gear.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
08-04-2016, 06:46 PM | #2 |
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: G9 shift cable adjustment
Was that's the original problem and why you changed the cables? If so, problem was not in the cables.
Anybody else jack with the carts differential? |
08-04-2016, 07:43 PM | #3 |
Not Yet Wild
Join Date: Aug 2016
Posts: 4
|
Re: G9 shift cable adjustment
The cart had been running fine, but either I had a short in the wiring or a bird built a nest in the engine compartment and it caught fire, because the next time I went to go riding it looks like there was a fire in the engine compartment and the covers on the cables were melted off in addition to the #2 accelerator cable and a vacuum hose was burned through. You could not move the handle to shift front or reverse.
|
08-04-2016, 07:51 PM | #4 |
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: G9 shift cable adjustment
Sounds as thought the cart was searching for a ground and found it through the cables, it happens.
take the cables off from the trans and see if you can shift it easily into forward and reverse. If not, your issue is in the trans. if it shifts fine, then its a cable adjustment which with new cables you should be able to just even them up in the middle and call it a day. |
08-06-2016, 07:59 AM | #5 |
Not Yet Wild
Join Date: Aug 2016
Posts: 4
|
Re: G9 shift cable adjustment
The transmission shifts fine. I adjusted the cables and everything works. Thanks.
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Shift Cable or F&R Cable Adjustment | Gas Yamaha | |||
shift cable | Gas EZGO | |||
Shift Cable | Gas Club Car | |||
Shift cable HELP!!!!! | Gas Yamaha | |||
ezgo shift cable adjustment? | Gas EZGO |