|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
03-01-2011, 09:47 AM
|
#11 |
|
Getting Wild
Join Date: Sep 2008
Posts: 117
|
Re: Lack of resistor cause cart not to go?
Ok, like an idiot I followed other wiring diagrams and didn't dig into Alltrax's site. They had a diagram that shows that I have that part wired correctly. That 12 volts should run through the red wire to 1 terminal only after throttle is depressed....I think that means pressed down....which I have. I still don't have power up though before I hit the pedal and the three blinking lights could be faulty pedal switch or shutting of DTS? It says to turn this off as a trouble shoot, but is this something I should need? Is turning it off just a bandaid?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-01-2011, 11:18 AM
|
#12 |
|
Getting Wild
Join Date: Sep 2008
Posts: 117
|
Re: Lack of resistor cause cart not to go?
Nevermind...see turkeyshooters post:
http://www.buggiesgonewild.com/elect...-please-3.html |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| resistor cart | Electric Club Car | |||
| 5TH speed resistor has a burned mark on resistor board and melted the wire | Electric EZGO | |||
| Old Resistor Cart | Electric EZGO | |||
| Resistor Coils - Lack of Power | Electric EZGO | |||
| 92 Ezgo Resistor Conversion gone bad... HIGH AMP DRAW and Lack of power HELP!!!!! | Extreme DC! | |||
Linear Mode
