Ran fine the day I bought it, a day later it doesn't

[Ingram]

Thanks for all the good ideas, but thus far none of them have been the answer...


The indicator is a row of lights showing the level of the charge the batteries have on them. It was showing full, when I first went and test drove/bought it. Brought it home, drove it around for awhile and when we returned home it showed to be just under 50%, so parked it in the garage, plugged up the charger and called it a good day. Came home, from work, the next day, indicator showed a full charge, went to go for a ride, but it just wouldn't go. Tried all the before mentioned suggestions, thanks everyone, but so far no luc.

Thx,
si

[meangreenmachine72]

If you have a meter and didn't try yet check the charge with that for total charge and check each battery. It has to be something simple Check switches for power in and out also you can disconnect from power source and check continuity (ohms) to make sure switches working properly.

Keep me posted.

[tag50]

Have you contacted the PO? Could be as simple as a kill switch.


.

[Ingram]

What is PO. I went and purchased a voltage meter and checked all four battieries, and all four check 12+ voktsge. I have Alton replaced the the fuses, that I can see. There were four in total, two flat fuses (on 10 and one 15) and then I found two inline 35v 25amp. Everything seems good, but still when I push the accelerator... Nothing. I agree in thinking it is something so simple, but I'm having no luck. It's almos like pushing the accelerator simply isn't engaging/kicking the motor on.

[jjance]

When you step on the throttle what does your charge indicator do? Does it stay pretty constant or does it drop down to 30-40% charge?

[Ingram]

stays consistent... Pushing the throttle doesn't seem to have any impact on the battery level indicator.

thx,
si

[mrgolf]

The cart has a throttle control called a MCOR. It sounds to me like the micro switch inside the mcor could be not making contact. With key off press the pedal about 10-20 times. If oxidation is in that switch that could clean it enough to make it work. If that makes it run all you need is to replace mcor.

[Ingram]

Turned the key off, pumped the throttle 20 plus times, turned the key on and still no go... When I first start pressing on the throttle, the hear a click, but that's it. One click at the very beginning of pressing on the throttle, but nothing else.

[jjance]

Do it again with the key on. Be careful you might get that one click and the cart might take off.

[Ingram]

Tried, still nothing...