Alltrax settings

[richieap]

where should my settings be on my alltrax ? such as over voltage and under voltage, throttle down rate ect.... , thanks

[kellybell]

I have a DCX 300, and I was wondering the same thing. Can I get it to go faster if I buy the cable, and fiddle with it? Great question!

[JohnnieB]

Here the way my DCX400 was set when I got it. Of course, I fiddled with it some after I installed it.

@Kelley: You'll have to get the cable to know how it is set before that question can be answered.

However, how tall are your tires, what air pressure are you running in them and what is the top speed you are now getting?

[richieap]

Originally Posted by JohnnieB

Here the way my DCX400 was set when I got it. Of course, I fiddled with it some after I installed it.

@Kelley: You'll have to get the cable to know how it is set before that question can be answered.

However, how tall are your tires, what air pressure are you running in them and what is the top speed you are now getting?

what is high pedal ? should i have that box checked ?

[scottyb]

HPD is a safety feature which prevents the cart from running if the gas peddle is not at 0 throttle when the control is powered up.
All of the program settings and options are explained on the Alltrax website along with a tutorial on how to program the control.

[richieap]

Originally Posted by scottyb

HPD is a safety feature which prevents the cart from running if the gas peddle is not at 0 throttle when the control is powered up.
All of the program settings and options are explained on the Alltrax website along with a tutorial on how to program the control.

ok thanks scottyb , been awhile since i did programming on this

[scottyb]

Originally Posted by richieap

ok thanks scottyb , been awhile since i did programming on this

Alltrax SPM controls use different software from the old AXE, DCX, NPX etc generation. The program looks a little different than the one posted.
What control are you asking about? Throttle settings are different for different models.

[richieap]

Originally Posted by scottyb

Alltrax SPM controls use different software from the old AXE, DCX, NPX etc generation. The program looks a little different than the one posted.
What control are you asking about? Throttle settings are different for different models.

DCX 400 , i was mainly concerned with over and under current settings , not sure where they should be set at

[scottyb]

27 and 55 are good limits for 36-48 volts.

[richieap]

Originally Posted by scottyb

27 and 55 are good limits for 36-48 volts.

thanks scottyb , ill set it at that