|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
05-07-2015, 04:05 PM | #1 |
Not Yet Wild
Join Date: May 2015
Posts: 3
|
09 RXV Danaher Edump Fail
I was given a remanufactured controller with a new motor / axle and wiring harness, plus all(?) the sensors and components that plug into the wiring harness so that they could be mounted on a different frame. When I turn the keyswitch to from OFF the solenoid clicks on for half a second and then back off. The diagnostic unit is showing an error for "EDUMP FAIL OFF". I believe I have the resistor and module wired correctly. There is another gray wire in the harness that is labelled "Resistor" on the wiring diagram. I don't have any information on where that is supposed to go and have not landed it anywhere. Any ideas what I could do next?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-07-2015, 10:04 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: 09 RXV Danaher Edump Fail
Grey wire goes to the resistor coil as a monitor to verify voltage. Heres where it goes, same terminal as larger white wire. Its a pain to get at.
|
05-07-2015, 10:19 PM | #3 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: 09 RXV Danaher Edump Fail
Deleted unrelated post. Wrong thread....sorry. Continue as above.
|
05-12-2015, 03:33 PM | #4 |
Not Yet Wild
Join Date: May 2015
Posts: 3
|
Re: 09 RXV Danaher Edump Fail
I was thinking that is where it goes, but couldn't be sure. Thank you very much! Problem solved!
|
|
|
Similar Threads | ||||
Thread | Forum | |||
RXV Fault Codes - DANAHER CONTROLLERS | Electric EZGO | |||
Ezgo fail | Electric EZGO | |||
Valve job / Fail | Gas EZGO |