If someone helps me get this g1 running I will give you everything off the spare!!!

[g1uncman]

Ok, so last week I purchased a later model g1, I know this bc it has the relay on the back of the passanger wheel hub. The solenoids have wires on front and back. Here is the problem, I have power running from my ignition switch, start stop switch ect, and through the solenoids. Starter turners over when jumped with a starter switch, but I still (with the throttle pushed in) and ignition turned to forward or reverse have no spark. I am getting power to my ignition coil but no spark at all when taken out or put in. I checked the cdi and all the components, with a test power wire (the one you connect to battery and get a light to glow) and had power on all the wires from ignition and cdi, ect.... The only one was the relay switch at the back, I would get a light on the top two and NOTHING at all on the bottom two holes coming off of the connector. Could this be the problem or what???? I WANT THIS CART RUNNING!!!! I also for 50 got a spare g1 in someones yard for 50 bucks to get parts off of! I got the body motor, everything!!!! When we jump the starter with the jumper cables and spark plug in the starter has a hard time spinning bc of compression, but when the spark plug is taken out she spins like no other and the engine sounds great, just we cannot get a spark, we have check all fuses also, (2). PLEASEEEE someone get back to me asap! I am off work today and hoping to get this bad boy running!!!!!

[rjeezy3209]

i had the same problem on my g2 and I traced every single wire on the cart and found multiple wire breaks and poor connections and a faulty pedal switch that would work sometimes and sometimes not .. I replaced all the wiring and put a toggle switch in place of pedal switch and it solved my problems I kept racking my brain so I know what your going thru let us know how its going

[ferdabutt]

so let me get this strait, starter motor turns, this ignition coil is reading the proper resistance on at both the ground and cap but the pedal wont work as far as turning the motor... right? if your wiring harness looks ok, with no shorts, then id have to agree your pedal switch is bad. also there is no real way to test your cdi to see if its working or what not. the only way is to get one from another that you know is working and plug it in. hard to find i know and thats why ill refer you to this sticky, http://www.buggiesgonewild.com/gas-y...i-20-16-a.html , its much cheeper and it works! haha i know because i followed it and it is was is running in my g1. also i know it a pain to buy the manual and trust me i dragged it out forever but when i did, it made life so much easier. there maybe one on ebay still that you can download for $11