97 EZGo series controller, cart won't run

[King Tutt]

Found issue. See email. About to send pics

[Clemsoncartguy]

Can we all see the issue as well? Or is it a secret? Haha

[King Tutt]

How do I post a pic

[King Tutt]

the group of four wires that come from under the cart on passenger side. 2 got lost in the install. 1 green goes to positive battery pole on driver side battery. 1 red goes to the toggle switch for the lights. Lights work. where does the other red and green wire go? I think the green (much longer then the red goes to B- terminal.

[scottyb]

No Sure if this helps but there is a red and green wire at the pedal box micro switch which activates the solenoid.

[King Tutt]

those are in tact these were laying down beside the battery. they come into the cart in front of the F/R switch. here is the pic..you can see them come in together

[scottyb]

I dont recognize either one of those as OEM wires so no way for me to know... you are going to have to do some detective work.

[King Tutt]

the green and white wire I traced back to the dash around the key switch. When I touched either of them to the positive battery terminal, my reverse chime worked. still nothing from battery life indicator. But a chime is a start. I feel the white goes to the pos terminal, as it can't reach anything else. If i touch the green to a neg terminal with white on positive terminal-loses the chime. so were does the longer green go to. Also, still no led from controller

[King Tutt]

took more apart-both white and green wires go to battery voltage indicator...Im getting 6v between the green and white at the meter. On the other end, the loose white wire definitlty goes to pos post on battery terminal. When I put the green wire on neg post on the same battery-I still get the reverse buzz. When I engage the throttle, buzz stops. When I have the green wire on the neg battery. and cart in neutral. There is no green led on controller. When I depress the throttle. Controller flashes error code 4-ITS. I checked the volts at the controller from the hi/lo pins-got 2.5V. I got the same volts at the ITS at the floor board. The micro switch at the ITS is new. Hope this helps further

[crushing]

Hey Scotty I am new to this site and this is the first golf cart I have ever owned. And it is a major fixer upper. On the wire diagram it shows the wire on the "A" terminal on the forward reverse switch going to the B+ post on the controller. The wire diagram I got from a local dealer is the same as yours but shows the wire on the "A" terminal going top A1 on the motor? Which one do I need to follow? Thanks for any help I am lost on this wiring