tires

[amcjeep]

Will something like these fit the stock 87 EZGO gas wheels?

http://www.ebay.com/itm/22x11-00-8-K...item518e3e4d90

[Ghall]

yes them will fit but you have to have a 4in lift

[popatop]

they will fit with a lift kit like Ghall said, but they are 2 ply tires, I think I would go with 4 ply tires,

[StoveBolt]

and did you notice that's tires only? and 8" tires are a bitch to install and look like a cushion for hemorrhoids with 22" tires.

[Marko44]

Originally Posted by StoveBolt

8" tires are a bitch to install and look like a cushion for hemorrhoids with 22" tires.

[StoveBolt]

Also your stock rims are not offset and I'm not sure, but don't think an 11" wide tire will clear everything even with a lift kit.

[tegger]

Stovebolt, where did you get a 7" lift for the ST350?
I've looked for lifts and everyone gives me the standard: It's already lifted!

Jay

[StoveBolt]

Originally Posted by tegger

Stovebolt, where did you get a 7" lift for the ST350?
I've looked for lifts and everyone gives me the standard: It's already lifted!

Jay

Hi Jay, I bought the lift and wheels used from one of the members here, It was a round dropped axle and used 1" pads on top the spring pads to get the 7"s, the 26" tires do rub on the brake pedal on sharp right turns when applying the brakes though. I think it came from LA Concepts.

On your ST350 are the springs mounted on the top or bottom of the axle? I know on the newer ones they are mounted on the bottom. They do make an ST axle that has the spring pads welded on top and bottom and moving the springs to the top makes a big difference. Check out my TXT that's what it has.

Then on back of your ST, use 2" blocks, I made my own out of 1.5 x 2" square tubing cut 3.5" long and a hole drilled through the middle to accept the alignment pins.