|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
10-03-2012, 10:39 PM | #1 |
Not Yet Wild
Join Date: Oct 2012
Posts: 2
|
new solinoid on 1999 ezgo
The old solinoid on my 1999 ezgo txt electric cart was burn on the post. i replaced it and installed the wire the same way as the old ones. The cart will not run. can anyone help me with this?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-04-2012, 10:35 AM | #2 |
Techno-Nerd
Join Date: Jun 2011
Location: West Virginia
Posts: 19,654
|
Re: new solinoid on 1999 ezgo
Welcome to BGW!
Which type drive system, Series or DCS? If there is a Run/Tow switch on the controller cover, it is a DCS. If it is a DCS and you didn't put it in Tow before changing the Solenoid, the controller may be blown. Lets us know what you got and we'll go from there. |
10-04-2012, 08:57 PM | #3 |
Not Yet Wild
Join Date: Oct 2012
Posts: 2
|
Re: new solinoid on 1999 ezgo
It is a series drive system.
|
10-04-2012, 10:03 PM | #4 |
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,358
|
Re: new solinoid on 1999 ezgo
TXT solenoid activation
Power starts on the White wire on the 36+ of the battery pack. Power travels to the charger receptacle, goes through a reed switch inside the receptacle and comes out on the red 12 gauge red wire. The red wire travels back through the loom to the Forward and reverse switch where it attaches to a micro. The other side of that micro has a blue wire attached that runs under the cart to the front and arrives at the keyswitch. The keyswitch then transfers power to a green wire which returns to the area of the Forward and Reverse switch. the power then goes through a 4 pin Molex connector and travels to the "pedal Box" (located under the floorboard of the car) where it goes through a micro and comes out on another red wire. That red wire comes back up to the Controller/F&R area where it once again goes through the 4 pin molex connector and continues on to the small post of the solenoid. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
solinoid qustion | Electric EZGO | |||
1999 48 volt club car solinoid checks | Electric Club Car | |||
how do I test f-n-r & solinoid | Electric EZGO | |||
85 EZGO Solinoid Question | Electric EZGO | |||
Is this a solinoid problem? | Electric EZGO |