Help with first gas cart

big mule · 01-07-2018, 05:28 PM

Quote:

Originally Posted by cart around

You need to get the right fuel pump.

The electric pump is over powering the float valve.

I think he has the crankcase mounted 24233-G1 "round" pulse type fuel pump (?).

LukeL · 01-07-2018, 05:44 PM

Quote:

Originally Posted by big mule

I think he has the crankcase mounted 24233-G1 "round" pulse type fuel pump (?).

Carb is brand new, and it's a round crankcase fuel pump. Not electric.

E36Racer · 01-07-2018, 06:08 PM

Well if it needs the choke to run then it’s too lean

Sent from my iPhone using Tapatalk

cart around · 01-07-2018, 06:12 PM

These threads are blending together. I know I just read one about somebody installing an electric pump. Apparently it wasn't this one.

Mooncarter · 01-07-2018, 06:31 PM

LOL. My take was he was wanting to go from electric BACK to mechanical and did not know where it went. My bad.

LukeL · 01-07-2018, 06:47 PM

It is a two cycle 3pg robin engine. It has a new carburetor and a new fuel pump and it only runs with the choke almost full. Who knows what could be wrong?

Sent from my iPhone using Tapatalk

LukeL · 01-07-2018, 10:28 PM

No ideas? I’m not real good with gas engines... enough to be dangerous.

Sent from my iPhone using Tapatalk

E36Racer · 01-08-2018, 07:02 AM

If it needs the choke it has to be too lean. Turn the mixture screw out .5 turn and see if that helps

Sent from my iPhone using Tapatalk

Spicyunicorn · 01-08-2018, 08:07 AM

Full choke to run could be worn crank seals

old231 · 01-08-2018, 08:30 AM

Make sure you have the right spark plug and it it at the correct gap. All rubber gas line connections should have a clamp. The new carb should be taken apart and cleaned. Plenty of other articles of new (dirty) carbs. Clean all jets and finish with a compressed air. And wear those safety glasses. Good luck.

01-07-2018, 06:08 PM	#13
E36Racer Gone Wild Join Date: Jan 2017 Location: Miami, FL Posts: 1,061	Re: Help with first gas cart Well if it needs the choke to run then it’s too lean Sent from my iPhone using Tapatalk

01-07-2018, 06:12 PM	#14
cart around Test before replacing Join Date: Aug 2013 Location: Ohio side of the Pennsylvania border. Posts: 3,495	Re: Help with first gas cart These threads are blending together. I know I just read one about somebody installing an electric pump. Apparently it wasn't this one.

01-07-2018, 06:31 PM	#15
Mooncarter Gone Insane Join Date: Oct 2016 Location: Richmond, VA Posts: 14,214	Re: Help with first gas cart LOL. My take was he was wanting to go from electric BACK to mechanical and did not know where it went. My bad.

01-07-2018, 06:47 PM	#16
LukeL Gone Wild Join Date: Jun 2017 Location: Savannah, GA Posts: 6,539	Re: Help with first gas cart It is a two cycle 3pg robin engine. It has a new carburetor and a new fuel pump and it only runs with the choke almost full. Who knows what could be wrong? Sent from my iPhone using Tapatalk

01-07-2018, 10:28 PM	#17
LukeL Gone Wild Join Date: Jun 2017 Location: Savannah, GA Posts: 6,539	Re: Help with first gas cart No ideas? I’m not real good with gas engines... enough to be dangerous. Sent from my iPhone using Tapatalk

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum

01-08-2018, 07:02 AM	#18
E36Racer Gone Wild Join Date: Jan 2017 Location: Miami, FL Posts: 1,061	Re: Help with first gas cart If it needs the choke it has to be too lean. Turn the mixture screw out .5 turn and see if that helps Sent from my iPhone using Tapatalk

01-08-2018, 08:07 AM	#19
Spicyunicorn Gone Wild Join Date: Jun 2015 Location: NW Iowa Posts: 1,669	Re: Help with first gas cart Full choke to run could be worn crank seals

01-08-2018, 08:30 AM	#20
old231 Not Yet Wild Join Date: Aug 2012 Posts: 57	Re: Help with first gas cart Make sure you have the right spark plug and it it at the correct gap. All rubber gas line connections should have a clamp. The new carb should be taken apart and cleaned. Plenty of other articles of new (dirty) carbs. Clean all jets and finish with a compressed air. And wear those safety glasses. Good luck.
old231 Not Yet Wild Join Date: Aug 2012 Posts: 57