lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Yamaha
Electric Yamaha Electric Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles



Post New Thread  Reply
 
Thread Tools Display Modes
Old 09-28-2021, 02:04 PM   #1
gtucker870
Not Yet Wild
Yamaha
 
Join Date: Nov 2019
Posts: 2
Default motor grommet/bushing

2002 Yamaha G19 with D&D motor and controller. Was having increasingly loud whining noise on acceleration and deceleration, and found that the input shaft bearing (not the sealed one) is worn badly. New input shaft kit on order and was wondering if I should go ahead and install the rubber grommet/bushing between the input shaft and motor while I have the motor off, even if that wasn't the cause of the noise. It didn't have one when I took the motor off.
gtucker870 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 10-14-2021, 04:23 PM   #2
gtucker870
Not Yet Wild
Yamaha
 
Join Date: Nov 2019
Posts: 2
Default Re: motor grommet/bushing

Update: Replaced the input shaft and bearings with the new rubber bushing as well. Differential noise went away. I had already ordered the outer sealed axle bearings and inner axle bearings just in case, so I installed them once they delivered. Everything is running smoothly now.
gtucker870 is offline   Reply With Quote
Old 10-17-2021, 09:53 AM   #3
ThrobThompson
Not Yet Wild
 
ThrobThompson's Avatar
Yamaha
 
Join Date: Sep 2020
Location: Owasso, OK
Posts: 8
Default Re: motor grommet/bushing

I hope this fixes your noise issue. I had the same issue and found that replacing the grommet stopped the noise for a few weeks, however, it came back. I haven't tried the "penny trick" but I may give it a try. I have also noticed there is a tiny bit of "play" when switching from forward to reverse or vice-versa. Concerned about that.
ThrobThompson is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Electric Yamaha


Thread Tools
Display Modes


Similar Threads
Thread Forum
Use Armature bushing on new motor? Spline grease? Electric Yamaha
Spline Grommet?? Motor Bumper??? Electric Yamaha
Pedal Box Grommet Electric EZGO
Motor spline bushing/spacer? Electric EZGO
Club Car electric motor bushing Electric Club Car


All times are GMT -5. The time now is 07:37 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.