lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas Club Car
Gas Club Car Gas DS, and Precedent golf cars



Post New Thread  Reply
 
Thread Tools Display Modes
Old 06-17-2010, 02:18 PM   #1
joe1992
Not Yet Wild
 
Join Date: May 2010
Posts: 43
Default governor on 1988 club car

okay i know this has been gone over many many times but on my 1988 club car where is my governor??? and how do i make sure everything is set back to stock. cause at times ill pin it for a minutes up my driveway and let off than itll backfire. i think its my governer??????


thanks!!!! joe
joe1992 is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 06-17-2010, 06:30 PM   #2
shadowman
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: governor on 1988 club car

follow the long rod that runs from carb along the side of the motor where clutches are back to gov, if someone messed with it it will be almost impossible to get it back to right................................
shadowman is offline   Reply With Quote
Old 06-17-2010, 08:34 PM   #3
joe1992
Not Yet Wild
 
Join Date: May 2010
Posts: 43
Default Re: governor on 1988 club car

there isnt one of thoose...... lol
joe1992 is offline   Reply With Quote
Old 06-18-2010, 03:51 PM   #4
shadowman
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: governor on 1988 club car

i hope someone else jumps in here but maybe they took the rod off..........anyone out here know if the 88 had that gov. rod??????.......................
shadowman is offline   Reply With Quote
Old 06-19-2010, 07:16 AM   #5
samsonone
Not Yet Wild
 
samsonone's Avatar
Club Car
 
Join Date: Mar 2010
Location: jacksonville Fl.
Posts: 49
Default Re: governor on 1988 club car

If it is a KF82 motor without the cart running hold the carb wide open then adjust the gov.rod. in the back. slide gov. lever to the front so when you let the carb. go back to the idle position the lever in the
back will be back. I think I remember that is the way been along time since I messed with a kf82

David correct me if I'm wrong
samsonone is offline   Reply With Quote
Old 06-19-2010, 09:08 AM   #6
joe1992
Not Yet Wild
 
Join Date: May 2010
Posts: 43
Default Re: governor on 1988 club car

well you see i am about 100 percent this is what i have right here and if u read the description it says its a coil and an rpm limiter built into one!!!! ive never heard of anyone else on here having one lol!!!!

http://cgi.ebay.com/ebaymotors/CLUB-...ltDomainQ5f100
joe1992 is offline   Reply With Quote
Old 06-19-2010, 08:18 PM   #7
shadowman
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: governor on 1988 club car

on late 1996 they built the ignotor into the coil but i have never heard of a rpm limitor built into a coil........on the older carts where the coils sits on the rear of engine drivers side the limtor is on top of the coil but not built it.................................
shadowman is offline   Reply With Quote
Old 06-20-2010, 09:41 AM   #8
joe1992
Not Yet Wild
 
Join Date: May 2010
Posts: 43
Default Re: governor on 1988 club car

haha well this is a mystery lol there isnt one nor is there wiring for it either!!!!!
joe1992 is offline   Reply With Quote
Old 06-20-2010, 05:59 PM   #9
shadowman
The Last Moja Morani
 
shadowman's Avatar
Club Car
 
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
Default Re: governor on 1988 club car

there isn,t a coil or limitor? i have seen them with the limitor on top of the coil and i have seen them with just the coil..........now that older cart may have an exitor coil for spark which is mounted under flywheel....................
shadowman is offline   Reply With Quote
Old 06-20-2010, 08:57 PM   #10
joe1992
Not Yet Wild
 
Join Date: May 2010
Posts: 43
Default Re: governor on 1988 club car

it has a coil under the flywheel
joe1992 is offline   Reply With Quote
Reply

Tags
governorcarclubflathead
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas Club Car


Thread Tools
Display Modes


Similar Threads
Thread Forum
1988 ezgo governor help Gas EZGO
club car gas governor removale Gas Club Car
94 club car governor question Gas Club Car
Governor 1991 club car Gas Club Car
fine tuning the Club car governor Gas Club Car


All times are GMT -5. The time now is 07:35 AM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. 2006-2017 Buggiesgonewild.com. All rights reserved.