|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
06-20-2010, 10:08 AM | #1 |
Gone Wild
Join Date: Aug 2009
Location: Eldon Missouri
Posts: 977
|
Rev limiter 98 CC (or lack thereof)
I was just reading a post by Joe1992 who was searching for his RPM limiter without success and guess what ? I have the same issue with a 98 CC. I installed a tach for a friend and did the usual tricks re the rod length, governor etc but the limiter is kicking in at around 2500 RPM's. I went to remove the limiter ground wire and,,,,,,,,,,,,,,,,,,,,,, there is no limiter where it normally resides (bolted to the front engine casing).
I didn't have time to track it down yesterday since he was needing to play a competition but my question is; did they relocate the limiters on some models and if so, for what reason ? Your wisdom will be much appreciated as always. Chris. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-20-2010, 05:57 PM | #2 |
The Last Moja Morani
Join Date: Jan 2007
Location: jumping from cart to cart
Posts: 8,975
|
Re: Rev limiter 98 CC (or lack thereof)
good question.did you feel for holes that might be there its possible the limitor was taken off?????? as far as i know they didn,t put them anywhere else..........................in late 96 they did away with the ignitor behind the limitor and incorperated it into the coil but the limitor was still in the same place.............................
|
06-20-2010, 11:06 PM | #3 | |
Gone Wild
Join Date: Aug 2009
Location: Eldon Missouri
Posts: 977
|
Re: Rev limiter 98 CC (or lack thereof)
Quote:
Chris. |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
vanguard lack of getty up and go | Big Block Talk! | |||
lack of power | Electric EZGO | |||
Lack of torque, I think | Electric EZGO | |||
Lack of power | Gas Yamaha |