06-14-2022, 04:23 AM | #1 |
Not Yet Wild
Join Date: Jul 2016
Posts: 14
|
1997 ezgo workhorse
put a new starter/generator on followed wiring diagram was running burnt wire
that goes from a1 to f2 |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
06-14-2022, 08:02 AM | #2 |
Gone Wild
Join Date: Jul 2020
Location: NC
Posts: 773
|
Re: 1997 ezgo workhorse
Hey Sam, I am not sure what you are saying or asking for here...full, or nearly full sentences and punctuation would be helpful. Are you trying to say that you put a new starter/generator on your cart, followed the wiring diagram, the cart was running with the new S/G, but then burnt up the wire from A1 to F2? If so, your problem is that you didn't wire it correctly. F2 is the hot wire from the switched side of the solenoid. A1 is the ground, gets the braided un shielded wire that attaches to the frame and the engine. There is a wire that goes from A2 to F1 on the S/G. The DF is the Green wire that goes to the voltage regulator.
|
06-22-2022, 04:10 AM | #3 |
Not Yet Wild
Join Date: Jul 2016
Posts: 14
|
Re: 1997 ezgo workhorse
found my issue thank you
|
|
|
Similar Threads | ||||
Thread | Forum | |||
1997 EZGO Workhorse | Gas EZGO | |||
1997 workhorse questions | Gas EZGO | |||
no spark 1997 workhorse | Gas EZGO | |||
1997 EZGO Workhorse 1200 | Gas EZGO | |||
1997 workhorse engine 295 or 350? | Gas EZGO |