throttle position sensor reading OL

weaselorlando · 05-25-2018, 04:18 PM

troubleshooting my G19 and I am getting a momentary "OL "reading at the very beginning of pedal movement on the orange & black wires. Is any "OL" reading pretty much conclusive for a bad sensor? Is there anyway to bypas the sensor for testing? Thanks

Weasel

cgtech · 05-25-2018, 07:00 PM

No way to easily/safely bypass it, and yes it sounds like it's bad. Assuming your meter was on the 0-20k ohm setting, not 0-2k setting.

weaselorlando · 05-26-2018, 09:44 AM

I only have the digital meter and it only has the auto scale. I will see if i can barrow an anolog meter. But while I was working on this problem, found the A1 wire luge was melted off the motor stud. The cable remained close to the stud , thats why i didnt see it initially. But i am embarresed that i started all this troubleshooting for nothing. I ran my old 4g cable to test the cart and it works. But now i see i have some other issues. I am starting a new thread to get some help. Thanks

05-25-2018, 04:18 PM	#1
weaselorlando Not Yet Wild Join Date: Apr 2015 Location: Peachtree City GA Posts: 55	throttle position sensor reading OL troubleshooting my G19 and I am getting a momentary "OL "reading at the very beginning of pedal movement on the orange & black wires. Is any "OL" reading pretty much conclusive for a bad sensor? Is there anyway to bypas the sensor for testing? Thanks Weasel

05-25-2018, 07:00 PM	#2
cgtech Over This Interview Is... Join Date: Jun 2012 Location: AZ Posts: 17,449	Re: throttle position sensor reading OL No way to easily/safely bypass it, and yes it sounds like it's bad. Assuming your meter was on the 0-20k ohm setting, not 0-2k setting.

05-26-2018, 09:44 AM	#3
weaselorlando Not Yet Wild Join Date: Apr 2015 Location: Peachtree City GA Posts: 55	Re: throttle position sensor reading OL I only have the digital meter and it only has the auto scale. I will see if i can barrow an anolog meter. But while I was working on this problem, found the A1 wire luge was melted off the motor stud. The cable remained close to the stud , thats why i didnt see it initially. But i am embarresed that i started all this troubleshooting for nothing. I ran my old 4g cable to test the cart and it works. But now i see i have some other issues. I am starting a new thread to get some help. Thanks

Similar Threads
Thread	Forum
Inductive Throttle Sensor mounting position?	Electric EZGO
G19 48V Throttle Sensor Reading	Electric Yamaha
Alltrax XCT throttle position	Electric EZGO
will idle at any throttle position	Gas Yamaha
Throttle position on carb	Gas EZGO

Today
BGW	Sponsored Links __________________ This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum