|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
06-29-2013, 02:53 PM | #1 |
Not Yet Wild
Join Date: Apr 2013
Posts: 22
|
Question about 1980 EZGO
Hey folks I need a little help, how do you get the rubber trim that goes around the edges of the cart back on? I took it off to do a little painting.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-23-2013, 06:38 PM | #2 |
Not Yet Wild
Join Date: Nov 2012
Location: Cumming Ga.
Posts: 12
|
Re: Question about 1980 EZGO
Did you get new trim ?? If so where did you get it.. I have not tried to put it on ,Is it that bad??
|
10-23-2013, 09:43 PM | #3 |
Gone Wild
Join Date: Jun 2013
Location: Salinas, Ca
Posts: 178
|
Re: Question about 1980 EZGO
gotta put it on the lip closest to the steering wheel first then use a baby screwdriver to wedge the front over the other lip. If that makes any sense lol. Might not hurt to heat it with a heat gun a bit so make it easier to flex.
Sonnym- you can buy it by the roll from almost any cart parts store, its expensive though cause it only comes by the roll and theres enough to do 2 carts. I think last time i saw it it was like 160$ for a roll. |
10-23-2013, 09:44 PM | #4 |
Gone Wild
Join Date: Jun 2013
Location: Salinas, Ca
Posts: 178
|
Re: Question about 1980 EZGO
by cart parts store I mean website....
|
10-25-2013, 09:12 PM | #5 |
Gone Wild
Join Date: May 2013
Posts: 320
|
Re: Question about 1980 EZGO
I read a thread some place on line were a guy put his into a pail of hot water to get good and warm so it was pliable.
I hate that you can not just buy a piece to do one cart. |
|
|
Similar Threads | ||||
Thread | Forum | |||
1980 electric ezgo | Electric EZGO | |||
1980 g1 oil pump question | Gas Yamaha | |||
1980 ezgo small wiring question | Electric EZGO | |||
1980 ezgo backfires | Gas EZGO | |||
1980 G1 carburetor question | Gas Yamaha |