|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
07-27-2013, 12:28 PM
|
#21 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 98 G16 starter runs, have spark, motor won't fire
Place the pushrods on a flat surface(like glass) and roll them. That will tell you if they are bent. Make sure you are on the low part of the cam lobe when you adjust each valve.
While you have the motor apart, take a pushrod and place it into the engine where it goes(on top of the tappet). Turn the crank by hand and make sure the pushrod goes up and down as you turn the crank. Check both of them. This will tell you that the cam is turning. When you reassemble, make sure that the pushrods are properly seated into the lifter(tappet) and the rocker. |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
07-27-2013, 12:34 PM
|
#22 |
|
Getting Wild
Join Date: Jul 2010
Posts: 119
|
Re: 98 G16 starter runs, have spark, motor won't fire
apparently I didn't pay attention to how I pulled out the push rods. Why are they seem short now.
 they "are off thier rockers" |
|
|
|
|
07-27-2013, 12:37 PM
|
#23 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 98 G16 starter runs, have spark, motor won't fire
The pushrods should each sit into a ball socket in the top of the lifter.
|
|
|
|
|
07-27-2013, 12:43 PM
|
#24 |
|
Getting Wild
Join Date: Jul 2010
Posts: 119
|
Re: 98 G16 starter runs, have spark, motor won't fire
I'm sure it is something I'm missing...
|
|
|
|
|
07-27-2013, 12:46 PM
|
#25 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 98 G16 starter runs, have spark, motor won't fire
Is the head seated all the way on the block?
If you shine a flashlight down inside where the pushrods go, are they seated into the socket in the lifter? |
|
|
|
|
07-27-2013, 12:57 PM
|
#26 |
|
Getting Wild
Join Date: Jul 2010
Posts: 119
|
Re: 98 G16 starter runs, have spark, motor won't fire
I'm such an ***. I' was hung up on the allighnment sleeves
Which stoke do you adjust them on . When I'm at TDC and the valves are dancing from I to E or the next stroke when they don't move? |
|
|
|
|
07-27-2013, 12:59 PM
|
#27 |
|
Gone Wild
Join Date: Oct 2010
Posts: 6,730
|
Re: 98 G16 starter runs, have spark, motor won't fire
The stroke where they don't move. That would be compression/power strokes.
|
|
|
|
|
07-27-2013, 01:00 PM
|
#28 |
|
Getting Wild
Join Date: Jul 2010
Posts: 119
|
Re: 98 G16 starter runs, have spark, motor won't fire
10 min.
|
|
|
|
|
07-27-2013, 01:19 PM
|
#29 |
|
Getting Wild
Join Date: Jul 2010
Posts: 119
|
Re: 98 G16 starter runs, have spark, motor won't fire
Over 150psi. WOW!
Oh and by the way it is now firing! Check your PM. Thank you Sir!!!!!!!!! I still have to get it all back together properly, I just slapped it back to see if it would fire. I'll test drive it later. I think there may still be some life in this 98'. |
|
|
|
|
07-27-2013, 01:26 PM
|
#30 |
|
Getting Wild
Join Date: Jul 2010
Posts: 119
|
Re: 98 G16 starter runs, have spark, motor won't fire
Just so you can see what you helped bring back to life...
I'll post driving results in a bit. (I'm real curious to see if I pick up some power. I bet i did) Ray |
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 98 G16 starter runs, have spark, motor won't fire | Electric Yamaha | |||
| 86 ez go 2 stroke i got spark and gas no fire? | Gas EZGO | |||
| 95 Club Car no fire on spark plug | Gas Club Car | |||
| Spark and Fuel! No Fire | Gas EZGO | |||
| G1 runs in forward no fire in reverse | Gas Yamaha | |||
Linear Mode
