|
Gas Club Car Gas DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
07-02-2018, 10:38 PM | #1 |
Not Yet Wild
Join Date: Jul 2018
Posts: 3
|
Convert TO pedal Start (wiring) 01 Turf 2
I have a 2001 Turf 2 gas that has been hacked on pretty good and missing the throttle switches and the wiring is a mess.
I’m trying to understand how the micro switches work so i can set the pedal back up. 1 switch closes contacts on the starter solenoid when the pedal is pressed and the other micro switch opens contacts on the kill switch when the pedal is pressed? When the pedal is released the kill contacts close? Does this mean that any time I’m driving the starter solenoid is energized? Is there another module that changes it from start mode to charge mode or is that internal to the generator? I also need to install a key but that should be pretty simple if i can get past the micro switch wiring. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-03-2018, 05:49 PM | #2 |
Gone Wild
Join Date: Oct 2009
Location: Lee County, Georgia
Posts: 521
|
Re: Convert TO pedal Start (wiring) 01 Turf 2
From the manual.......THE GENERATOR CIRCUIT (FIGURE 12-4)
The generator circuit consists of the starter/generator, voltage regulator, solenoid, the battery, and connecting wires. When battery power is first supplied to the starter/generator, the starter/generator turns the engine at low RPM (approx. 700). Once the engine starts running, it then drives the starter/generator. At any engine RPM over 1215 (3000 starter/generator RPM), the starter/generator functions as a generator, supplying charging current to the battery. To prevent battery overcharging, the voltage regulator senses battery voltage, and by opening and closing an electronic switch, it controls the amount of charge going to the battery. |
07-03-2018, 06:07 PM | #3 |
Gone Wild
Join Date: Oct 2009
Location: Lee County, Georgia
Posts: 521
|
Re: Convert TO pedal Start (wiring) 01 Turf 2
Here is a parts list for your cart. On page 6-6 you will find the electrical drawing.
|
07-03-2018, 11:58 PM | #4 |
Not Yet Wild
Join Date: Jul 2018
Posts: 3
|
Re: Convert TO pedal Start (wiring) 01 Turf 2
|
|
|
Similar Threads | ||||
Thread | Forum | |||
TXT wiring help for big block with pedal start. | Clone Engine Swaps | |||
Factory pedal start with recoil start clone | Clone Engine Swaps | |||
99 Turf II, Crank, No Start | Gas Club Car | |||
08 turf 2 will not start | Gas Club Car | |||
Anybody Convert To Key Start??? | Gas Club Car |