|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
01-06-2010, 02:04 PM | #1 |
Not Yet Wild
Join Date: Jan 2010
Location: NorthWest
Posts: 22
|
Milling Cylinder Head
Hello, I am rebuilding my 95 Yamaha G-9 4 strk and am curious about raising the compression slightly. I am installing the 50mm piston, as well as complete valve job, including porting and polishing the head. Does anyone have a tried and true spec. as to how much I can successfully machine off the cylinder head, without causing any damage. Thanks Joe
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Fe290 Cylinder head Torque | Gas Club Car | |||
Wanted: Robin (ezgo) 295cc cylinder head | Golf Carts and Parts | |||
77' Marathon cylinder | Gas EZGO | |||
80-88 ez go cylinder head wanted | Golf Carts and Parts | |||
No Compression One Cylinder | Gas EZGO |