|
|
|||||||
| Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
  |
|
|
Thread Tools | Display Modes |
06-19-2014, 12:42 PM
|
#1 |
|
Not Yet Wild
Join Date: Jun 2013
Posts: 5
|
G1 Crankshaft oil seal replacement tips?
Trying to change the oil seals on my G1. Ruined two seals on each side trying to install them. When I press the seal into the hole, the lip gets caught on the edge. Is there a trick or technique that I am missing? Or do I just need to be more careful? Any suggestions welcome. Thanks.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
06-19-2014, 06:41 PM
|
#2 |
|
Sometime's............
 Join Date: Oct 2007
Location: Tacoma Washington
Posts: 11,875
|
Re: G1 Crankshaft oil seal replacement tips?
Are you useing OEM or aftermarket seals?
|
|
|
|
|
06-19-2014, 08:11 PM
|
#3 |
|
Gone Wild
Join Date: Oct 2010
Location: Pittsburgh Pa
Posts: 1,551
|
Re: G1 Crankshaft oil seal replacement tips?
Try putting a little bit of 2 cycle oil on them. Then get yourself a block of wood and tap them in using a hammer....working the seal in top to bottom, left to right until the seal is seated completely in the casing. Getting them started square is key.
|
|
|
|
|
06-20-2014, 12:18 AM
|
#4 |
|
Not Yet Wild
Join Date: Jun 2013
Posts: 5
|
Re: G1 Crankshaft oil seal replacement tips?
Smallblock: I don't know if they are OEM, so they probably aren't. Does it make a difference? If so, where do I get OEM seals? Thanks.
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| 88 2PG Crankshaft - Think it will seal? | Gas EZGO | |||
| Crankshaft seal installation? | Gas Columbia ParCar | |||
| Crankshaft Seal 89 EZGO | Gas EZGO | |||
| Crankshaft Seal Problem | Gas EZGO | |||
| 85 gas 2cycle crankshaft seal replacement difficulty | Gas EZGO | |||
Linear Mode
