|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
10-08-2014, 02:40 PM | #1 |
Not Yet Wild
Join Date: Oct 2014
Location: Austin, Texas
Posts: 7
|
Help with Carburetor adjustment on G29
Can anyone direct me on how to adjust the carburetor air intake on a G29?
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-08-2014, 04:32 PM | #2 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Help with Carburetor adjustment on G29
Pilot screw (the one at an angle) 1-1.5 turns out from fully closed. Butterfly adjuster screw set to zero gap. I shine a flashlight in one end, adjust till no light at other end.
|
10-08-2014, 06:47 PM | #3 |
Not Yet Wild
Join Date: Oct 2014
Location: Austin, Texas
Posts: 7
|
Re: Help with Carburetor adjustment on G29
Cgtech, thank you very much. Been having sputtering (bogging) on acceleration after I tightened the governor. I'm assuming it's lack of air. Thanks a lot for the information.
|
10-09-2014, 12:42 AM | #4 |
Not Yet Wild
Join Date: Oct 2014
Location: Austin, Texas
Posts: 7
|
Re: Help with Carburetor adjustment on G29
cgtech, Is this the Pilot Screw?
|
10-09-2014, 09:28 AM | #5 |
Over This Interview Is...
Join Date: Jun 2012
Location: AZ
Posts: 17,449
|
Re: Help with Carburetor adjustment on G29
Yes, i forgot yours is capped (per EPA spec).
|
03-30-2019, 09:23 AM | #6 |
Not Yet Wild
Join Date: May 2013
Posts: 21
|
Re: Help with Carburetor adjustment on G29
My cart is running lean so I would turn the screw in correct?
|
03-30-2019, 09:38 AM | #7 |
Gone Wild
Join Date: May 2012
Location: fl
Posts: 225
|
Re: Help with Carburetor adjustment on G29
|
03-30-2019, 09:45 AM | #8 |
Not Yet Wild
Join Date: May 2013
Posts: 21
|
Re: Help with Carburetor adjustment on G29
Thank-you
|
03-30-2019, 09:47 AM | #9 |
Not Yet Wild
Join Date: May 2013
Posts: 21
|
Re: Help with Carburetor adjustment on G29
Can you just remove the plastic cap on the screw for a little more adjustment?
|
03-30-2019, 09:56 AM | #10 |
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,313
|
Re: Help with Carburetor adjustment on G29
Yes. Turn the screw in until lightly seated and count the number of turns. it gives you a baseline.
Remove the cap carefully. |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
carburetor adjustment | Gas Club Car | |||
Need help with Carburetor adjustment | Gas EZGO | |||
Carburetor Adjustment Question | Gas Club Car | |||
1980 G1 Carburetor adjustment | Gas Yamaha | |||
Carburetor Adjustment for Club Car DS | Gas Club Car |