07-05-2010, 01:46 PM | #1 |
Not Yet Wild
Join Date: Jun 2010
Location: Kentucky
Posts: 24
|
93 CC Seat Question
I have a 93 Gas Club Car, and I am looking into putting new seats on it. My question is can I put the 2001-up style seat and seat back on my cart? The only real diff I see is the hip rail setup and the one piece back looks like it mounts a little different. If this has been covered before, I apologize. I searched and found nothing. Any info from someone who has done this would be great. Pics would help too.
Thanks Brad |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-06-2010, 10:11 PM | #2 |
Gone Wild
Join Date: Jan 2007
Location: La Porte Indiana
Posts: 1,392
|
Re: 93 CC Seat Question
the bottom is easy it just sits there. although be advised that if you are wide in the hips as i am(read fat!) the newer seats are about 2 inches narrower than the older ones.
from what i have read you need to change the whole bracket that holds the seat back or be able to do some fab work. never tried this one myself though. but I can't remember seeing pictures of a one pc back on the aluminum colored frames...? -Aaron |
07-07-2010, 06:52 PM | #3 |
Not Yet Wild
Join Date: Jun 2010
Location: Kentucky
Posts: 24
|
Re: 93 CC Seat Question
4vertical,
Thanks for the reply. When you say 2 inches narrower, are you talking side to side or front to back? As far as the back goes, I have access to plenty of aluminum and a high frequency tig rig. I will probably put a rear seat kit on the cart anyways so I can just fab something for the seat back at the same time. Last edited by bar197; 07-07-2010 at 06:53 PM.. Reason: caint spel |
07-07-2010, 09:00 PM | #4 |
prop. A$$hole's Garage
Join Date: Dec 2007
Location: Deep inside the Central Scrutinizer (77096)
Posts: 1,587
|
Re: 93 CC Seat Question
The new style seat bottoms are narrower side to side because the plastic hip restraints eat up some of the cushion width.. You'll need the new style backrest brackets to upgrade to the one-piece backrest.. These can be picked up cheap at most cart shops, as they are pulled off to fit a rear seat.. I picked up a complete used backrest and brackets for $50 at a local cart shop, they had a pile of them out back that were pulled off of carts to install rear seat kits..
Here's a couple of pics of my 1996 DS with the old style bottom cushion and the new style backrest.. |
07-07-2010, 09:07 PM | #5 |
Not Yet Wild
Join Date: Jun 2010
Location: Kentucky
Posts: 24
|
Re: 93 CC Seat Question
cc-john,
This is what I needed. Thanks for the reply and the pics |
|
|
Similar Threads | ||||
Thread | Forum | |||
Want to trade Clubman seat for EZGO seat | Golf Carts and Parts | |||
Oh gosh - silly seat question | Design Center | |||
Installing rear seat question ??? | Electric EZGO | |||
New seat hardware question | Gas EZGO | |||
rear seat question | Electric EZGO |