07-27-2014, 04:27 PM | #11 |
Guest
Posts: n/a
|
Re: 02 not reverse
the 3 prong switch is the one i want to change or all 3 ?
i ask cause the 3 wire one is $20 the others are $5 |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
07-27-2014, 04:32 PM | #12 |
ΜΟΛΩΝ ΛΑΒΕ
Join Date: Nov 2012
Location: West Virginia
Posts: 4,094
|
Re: 02 not reverse
I think the 3 wire one, but I'm not sure, don't have a series 48 volt near me right now to look at the switches in person to tell. Isn't it always the most expensive one?
|
07-27-2014, 04:59 PM | #13 |
Guest
Posts: n/a
|
Re: 02 not reverse
what the heck does the resistor do ?
why is there 3 wires on #2 switch and only 2 are used ? will replacing #2 with a 2 pole switch be ok ? should i just replace #3 or all ? |
07-27-2014, 05:07 PM | #14 |
ΜΟΛΩΝ ΛΑΒΕ
Join Date: Nov 2012
Location: West Virginia
Posts: 4,094
|
Re: 02 not reverse
The resistor is for half speed reverse operation, but as for the other questions, I'm clueless!
|
07-27-2014, 05:38 PM | #15 |
Guest
Posts: n/a
|
Re: 02 not reverse
|
07-27-2014, 06:25 PM | #16 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: 02 not reverse
It bypasses the resistor in the forward direction. It's hard to tell in your drawing but if it was drawn out schematically the signal would come into the top common connection and if it was in reverse it would go out the NC connection through the resistor where it would be attenuated further to give a lower speed in reverse. Or out the NO where it would be unchanged. Disconnect the common wire and you should be able to check the switch with an ohmmeter.
|
07-27-2014, 08:18 PM | #17 |
Guest
Posts: n/a
|
Re: 02 not reverse
green goes to controller and the others go to mocr
|
07-27-2014, 08:58 PM | #18 |
Gone Wild
Join Date: Feb 2011
Location: Chattanooga TN
Posts: 2,105
|
Re: 02 not reverse
I drew this on a napkin where it will be easy to understand. This is what you got
https://www.flickr.com/photos/283192...8076/lightbox/ Hope this helps |
07-27-2014, 09:57 PM | #19 | |
Guest
Posts: n/a
|
Re: 02 not reverse
Quote:
|
|
07-27-2014, 10:48 PM | #20 |
Guest
Posts: n/a
|
Re: 02 not reverse
ok i got it !!! so i will replace the 3 prong switch
|
|
|
Similar Threads | ||||
Thread | Forum | |||
wiring a reverse light to the reverse buzzer? | Gas Yamaha | |||
Goes in reverse when switch is in forward. does nothing with swicth in reverse | Electric EZGO | |||
Reverse won't go but if I pump gas it slams into reverse | Electric Club Car | |||
Foward in reverse and reverse in forward | Electric Club Car | |||
Reverse alarm stuck - motor won't run forward or reverse | Electric EZGO |