'78 de 40 speed board

arc flash · 06-15-2011, 03:50 PM

hello and thank you for your time. i have a 78 de 40 and the speed board has turend "crispy" and needs replaced. the problem im having is i can only find the earlier board wich has five holes insted of the six holes that the current board has. when i took the board off to look at it the fifth and sixth studs were tied togather with a thin flat ribbon jummper. is this correct? and is the sixth stud just an over run for the wipper? will it hurt anything to use the five hole board?

thanks again

kenny

06-15-2011, 03:50 PM	#1
arc flash Not Yet Wild Join Date: Jun 2011 Posts: 18	'78 de 40 speed board hello and thank you for your time. i have a 78 de 40 and the speed board has turend "crispy" and needs replaced. the problem im having is i can only find the earlier board wich has five holes insted of the six holes that the current board has. when i took the board off to look at it the fifth and sixth studs were tied togather with a thin flat ribbon jummper. is this correct? and is the sixth stud just an over run for the wipper? will it hurt anything to use the five hole board? thanks again kenny
arc flash Not Yet Wild Join Date: Jun 2011 Posts: 18

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Forum
84 ez go speed control board	Electric EZGO
5TH speed resistor has a burned mark on resistor board and melted the wire	Electric EZGO
new to board Hi all	Gas EZGO