No spark, No matter what I try

[mrcars1515]

We have a 2003 gas ezgo
It was stored for a long time
It ran but would stop after a short time
We drove it in the garage
Tried to find wires for the reverse buzzer
There was no reverse buzzer
The oil pressure switch is disconnected
Tried test light to the solenoid, by accident the neg of the coil to positive and got a spark and thats when the issue began

Checked the ignitor and coil on another cart, and it worked fine
Installed new pulsator works, ohms out at 21 ohms
Installed new ignitor, coil, and solenoid, no spark
Tested components in another ezgo, all components worked fine

9 volts at the positive at the coil while cranking
Testing at the coil while cranking, we get pulse flashes on the ignitor leads

Installed jumper from battery to chassis for ground

Get no high voltage or spark on plug or testlight

We have read many posts, and yet cannot get a spark, any ideas? THANK YOU

[trig123]

Originally Posted by mrcars1515

We have a 2003 gas ezgo
It was stored for a long time
It ran but would stop after a short time
We drove it in the garage
Tried to find wires for the reverse buzzer
There was no reverse buzzer
The oil pressure switch is disconnected
Tried test light to the solenoid, by accident the neg of the coil to positive and got a spark and thats when the issue began

Checked the ignitor and coil on another cart, and it worked fine
Installed new pulsator works, ohms out at 21 ohms
Installed new ignitor, coil, and solenoid, no spark
Tested components in another ezgo, all components worked fine

9 volts at the positive at the coil while cranking
Testing at the coil while cranking, we get pulse flashes on the ignitor leads

Installed jumper from battery to chassis for ground

Get no high voltage or spark on plug or testlight

We have read many posts, and yet cannot get a spark, any ideas? THANK YOU

Remove the blue wire going to small terminal of solenoid and connect a jump wire to that post from positive side of battery. It will start spinning over when you do this but that will eliminate the micro-switch under floor mat. See if you got spark