lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas Yamaha
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-15-2012, 08:45 PM   #9
Vegas modded 420
sho305's Avatar
Join Date: Jun 2009
Location: West MI
Posts: 15,320
Default Re: torque kit

G9, just crank up the tension cable don't bother with a short belt (imo). If you don't have one on there buy it or make one, its under the gen pulley. You can crank them tight enough to cut your top speed easily and it helps take off quiet a bit at that point. That is how I set mine I used a hand gps to check speed over 100yd run or so and stopped on a steep little hill to gauge take off.....about 6 runs I had it dialed in to same top speed and much better take off on the hill (take off from engine not running). You could also try that HD kevlar belt it is little wider and rides higher on secondary, that should help some. A cut secondary also helps take off to 5mph or so, but most important it lets it rev up faster. Of course before you do those things clean/service the clutches and make sure they are working right.
sho305 is offline   Reply With Quote
Go Back   Buggies Gone Wild Golf Cart Forum > Golf Cart Repair and Troubleshooting > Gas Yamaha

Thread Tools
Display Modes

Similar Threads
Thread Forum
Lug nut torque Electric Club Car
Need More Torque Lifted Golf Carts
torque for my g2 Lifted Golf Carts
Put torque kit on G2 Gas Yamaha
Electric Torque vs Gas Torque Electric Club Car

All times are GMT -5. The time now is 02:11 PM.

Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
This Website and forum is the property of No material may be taken or duplicated in part or full without prior written consent of the owners of 2006-2017 All rights reserved.