Lift Kit

[Fishing Dude]

They go on the rear axle, as do those spasers. Try under the springs, with U bolts going on the springs.

[sweade]

"I get that".My old bronco was easier to lift.
I'll post a pic.Maybe i have a ******* cart?

[groundpounder]

what year club car do you have?

[sweade]

1999 ds club car

[sweade]

Here a picture of the rear axle as is

[groundpounder]

I'm not to familiar with club car. but i would say that's a flip kit. your leaf spring will go on top of the axle instead of on the bottom like in your stock pic.

[dirtysouth]

Originally Posted by sweade

k, pics attached (don't know if it worked, first time adding pics). i already installed the front, the rear came with 6" square u-bolts and brackets Don't know how they go.

SW, What year is yoor Club Car, gas or elec.?

[sweade]

1999 Electric

[dirtysouth]

Originally Posted by sweade

1999 Electric

You're going to do a spring over lift on the rear. You have to remove the rear leaf springs one at a time. Lower the axle, reinstall the leaf on top of the axle. The black block then go's on top of the axle, between the axle and leaf spring. The plate on the u-bolt go's all the way to the top (suare end of u-bolt). Install the u-bolt from the top of the leaf spring going down past the black block and the axle. The u-bolt then goes through the original holes in the brake cable plate. The shocks bolt up to the plate on the u-bolt. Repeat for other side. Hope this helps. ( As most know I'm not the best at instructions.).

[Boris]

I can't get this out of my mind ...........

"Just received in the mail a Red Hack 6" lift kit with spinkles for Club Car." ............

What in the H3LL is a "spinkle"?