|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
02-17-2016, 04:10 PM
|
#1 |
|
Getting Wild
 Join Date: Feb 2016
Location: Bluffton, SC
Posts: 122
|
New entire brake assembly hubs won't fit back on backing plate
Changing out the entire brake assembly on a 99 TXT. Everything is hooked up except the brake cables so I test fit the hub and it slid right on. Next went that to attach the brake cable and I had to pull the attachment point on the new backing plate back to put the pin in, which obviously engages the brakes so the hub wont slide back on. Adjustment screw is down as far as it can go and still can't get the hub to go on. Any ideas how to make them work so I can get the hub back on?
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
02-17-2016, 04:16 PM
|
#2 |
|
maintaining a low profile
Join Date: Oct 2009
Location: SW Virginia USA
Posts: 6,316
|
Re: New entire brake assembly hubs won't fit back on backing plate
Don't know anything about EZGO, but I'd check the adjustment of the brake pedal.
|
|
|
|
|
02-17-2016, 04:20 PM
|
#3 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: New entire brake assembly hubs won't fit back on backing plate
There is a cable length adjustment, sort of a 2 into one device with a threaded rod that is double nutted... that double nut is your adjustment
 |
|
|
|
|
02-17-2016, 04:25 PM
|
#4 |
|
Getting Wild
Join Date: Feb 2016
Location: Bluffton, SC
Posts: 122
|
Re: New entire brake assembly hubs won't fit back on backing plate
I'll give it a whirl, where my cable ended and where the new attachment point was nearly 1/2 inch off so I wasn't sure if I could adjust those nuts where the equalizer bar was enough to reach..will have to wait till Friday thanks guys!
|
|
|
|
|
02-18-2016, 04:47 PM
|
#5 |
|
Getting Wild
Join Date: Feb 2016
Location: Bluffton, SC
Posts: 122
|
Re: New entire brake assembly hubs won't fit back on backing plate
Thanks for the advice gentleman! Got them on after adjusting the cable a bit and worked like a charm! Also Scottyb got my Alltrax from ya about a year ago never been happier with my carts performance thanks!
|
|
|
|
|
02-18-2016, 04:57 PM
|
#6 |
|
Happy Carting
Join Date: Dec 2007
Location: Southern California
Posts: 73,419
|
Re: New entire brake assembly hubs won't fit back on backing plate
Good to hear both things! Thanks for the prop
|
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Torque -Brake Cluster Backing Plate | Electric EZGO | |||
| TXT Brake hubs | Golf Carts and Parts | |||
| EZ-GO front wheel hubs assembly | Golf Carts and Parts | |||
| Carryall Seat Back Assembly | Golf Carts and Parts | |||
| switching the brake hubs | Electric Club Car | |||
Linear Mode
