|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
05-21-2013, 11:04 AM | #1 |
Gone Wild
Join Date: Apr 2013
Location: Eastern SD.
Posts: 276
|
G-1 starter Gen. fan blade measurement?
I was just informed by a vendor that the fan blades are no longer available anywhere so I would like to make one. Can someone measure theirs for me and post the diameter here.
Thanks for your help! Chris |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
05-21-2013, 11:44 AM | #2 |
Not Yet Wild
Join Date: May 2013
Posts: 20
|
Re: G-1 starter Gen. fan blade measurement?
Believe it or not I just took mine off today to try to find a new one ill post later today with measurements or a vendors phone number if I fine one.
|
05-21-2013, 04:02 PM | #3 |
Gone Wild
Join Date: Apr 2013
Location: Eastern SD.
Posts: 276
|
Re: G-1 starter Gen. fan blade measurement?
That would be very much appreciated. Thanks
|
05-21-2013, 07:26 PM | #4 |
Not Yet Wild
Join Date: May 2013
Posts: 20
|
Re: G-1 starter Gen. fan blade measurement?
I too couldn't find one. But a buddy of mine suggested that maybe the fan off of a gm alternator just might replace it. It can be stripped down to just the fan and then you should be able to drill it out for the screws that hold it on.
I did measure mine and below is what I got. Overall diameter across the screw holes is 2 9/16 Center to center of screw holes is 1 7/8 Center hole diameter 1 1/4 Both of my blades are broken off so I can't give you those measurements |
05-21-2013, 10:45 PM | #5 |
Gone Wild
Join Date: Apr 2013
Location: Eastern SD.
Posts: 276
|
Re: G-1 starter Gen. fan blade measurement?
I really appreciate the effort you put into this. I was thinking of making mine out of a sheet of aluminum. The fan diameter isn't real critical as long as it moves a good flow of air down the outside of the housing. The fan blade on an alternator is designed to draw air through the internal windings and armature. I'm not too sure that would be effective in this application. Good thought though.
Thanks again. |
05-23-2013, 09:11 AM | #6 |
Not Yet Wild
Join Date: May 2013
Posts: 20
|
Re: G-1 starter Gen. fan blade measurement?
I am gonna flip that alternator fan around backwards and try it. If I still don't get good airflow then I'm gonna open up a few of the fan blades and see what that does. I'll post the results later.
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
snow blade/ winch mounting ezgo electric | Electric EZGO | |||
I need a Sawzall blade sponsor! | Lifted Golf Carts | |||
Motorized Roller blade for sale | Autos/Side x Sides/ATVs/4x4's | |||
found a snow plow blade for 1982 ezgo | Gas EZGO | |||
snow blade for sale | Golf Carts and Parts |