cart stopped working

[george forget jr]

my 1997 EZ-GO cart stopped going ? I can hear the motor spinning, both axels and hubs are good. ? any Ideas what to do next.

[scottyb]

Originally Posted by george forget jr

my 1997 EZ-GO cart stopped going ? I can hear the motor spi good on both . ? any Ideas what to do next.

I think we have a bad cel connection

Do you mean to say you can hear the motor spin in Forward and Reverse but the cart does not move?
If so, the common cause is a stripped hub. Remove hub cap and dust over ... check to see if the axle spins and wheel does not. Driver side is most common. But either side may fail.

[george forget jr]

Did that when jacked up on one side the raised wheel turns and I can not stop it . Same with the other side.

[scottyb]

But with the cart on the ground it does not move? Likely, one of the hubs is stripped on the axle splines.

[COURTESYCART]

If the hubs arn't stripped than the electric motor connection to the rear diff. I have seen a few do that, but more common is the hubs.

[george forget jr]

Originally Posted by COURTESYCART

If the hubs arn't stripped than the electric motor connection to the rear diff. I have seen a few do that, but more common is the hubs.

Thank ! Yep it was the connection to the motor. I will finish it up tomorrow . Again thanks for your help..